Questions and Answers for ROBERTS 1-7/8 in. x 75 ft. Roll of Max Grip Carpet Installation Tape

A:  Working work great on garage floor at any temperature (just make sure you clean the floor really well).

A:  Thank you for your inquiry. For optimum performance of materials: always follow the floor covering manufacturer's installation guidelines related to site preparation and environment acclimation. Typical install conditions: between 60 - 85 degrees F and 30-50% ambient RH.

A:  It probably would but both surfaces need to be clean and it's not actually rated for outdoor use so who knows if it would last.

A:  I'm sure it will. It stick fast to 35 year old wood decking lumber.

A:  It should be double sided, so apply to carpet, remove backing, press carpet down.

A:  The is a double sided tape with paper to pull off the upper side when installing the carpet.

A:  It's 2 sided tape, super sticky. We took a pair of scissors, cut the length we wanted to use, (3 to 4 inches) 3 to 4 times per carpet square and placed it on the bottom. Sometimes we used more if the tile was in a high traffic area or we new we would be sliding furniture across it. We used ours on a particle board type, raised sub floor system, but it will stick to pretty much anything. Be careful pulling up, (either to reposition or remove) because some times it sticks to the carpet and pulled the wood particles up with it, (like I said, super sticky). Once we had 3 or four pieces on the tile, (near the edges and pressed down firmly) we would carefully peel of the paper backing, so as to not remove it from the carpet piece. Hope that helps.

A:  Thank you for your inquiry. Make sure the subfloor surface is thoroughly clean and dry. Apply tape to fit perimeter of the installation area. Once the flooring is ready to place, Peel the protective cover away and lay the flooring on top of the tape. Roll the flooring to secure the flooring into the tape. Refer to the directions on the carton for further details or contact technical services.

A:  Unfortunately, no. This product is not intended for foot-traffic use.

A:  yes, Double sided tape acrylic with reinforced scrim webbing for extra strength adhesion of vinyl flooring, wall base, stairs and treads, and vinyl trim.

A:  Cutback adhesive is very destructive to acrylic type products such as adhesives and tapes. It is not recommended to use this tape over cutback adhesive.

A:  It sticks to everything even material.

A:  Probably not for long, best contact iis achieved with both full surfaces .

A:  Roberts Max Grip Tape is a highly effective pressure sensitive tape engineered for use over unfinished substrates such as concrete or wooden subfloors. This tape is considered a permanent installation tool for carpet or other floor coverings and should not be installed onto Finished flooring such as Hardwood flooring, Carpet, LVP,LVT, Stone Tile etc. Damage may occur upon removal.

A:  I would want a level surface cause over time the vinyl will settle into grooves

A:  Ensure the existing floor covering is dry clean and free of any contaminates that could inhibit the bond of the tape. Unless the grout lines are excessive, the tape should adhere well. Always roll the installed flooring to ensure a tight bond between the flooring and the tape.

A:  Yes, Ensure the existing floor covering is dry clean and free of any contaminates that could inhibit the bond of the tape. Always roll the installed flooring to ensure a tight bond between the flooring and the tape.

A:  It is a very sticky tape. It holds great to our particle board flooring system and really keeps the carpets in place. I would imagine it would stick, but we haven't used it on something smooth like that?

A:  The stuff is really sticky and may work fine. How long it holds may depend on temperature changes if it's in a garage for Instance. Big swings may break down the holding power.

A:  Max Grip Tape is highly effective installation tape that offers a permanent bond and is recommended for indoor and outdoor use. It is always recommended to follow a manufacturer's recommended installation guidelines. Reflectix-(Unfaced Reflective Roll Insulation) sheets recommend staple down installation for best results.

A:  No, Max Grip Tape is considered a permanent tape and may damage fibers related to the futon cushion.