Questions and Answers for Everbilt 18 in. x 22 in. Sump Pump Basin

A:  Hello Kenneth. You can use our 4 in. Molded Basin Inlet Hub, Home Depot Internet # 300460483 SKU, Model # SIH-4 available on The Home Depot website. You can also use the inlet hub included in the Everbilt 18 in. Basin Cover for Sump and Sewage Basins, Home Depot Store SKU # 100002754, Model # SF2000E.

A:  Hello Morey. We are not in a position to answer this question. We suggest you call a licensed plumber or basement waterproofing contractor.

A:  Hi Doug. This basin is not perforated, but our Model SF20-DR is perforated and it is available at thehomedepot.com.

A:  No it is not perforated.

A:  Hello DIYperson. This basin can be used for outdoor applications.

A:  Hello Antony. This sump basin has a total capacity of 20 US-gallons.

A:  Hello. The Measurement Guide can be found at this link: https://images.thdstatic.com/catalog/pdfImages/f7/f7614fdc-36e2-4276-8da3-07f3e5fa330b.pdf

A:  Hello RachERach. The Everbilt pump will fit in this basin. The basin provides a very stable base for any sump pump provided that the basin is installed level and per the installation instructions found at this link: https://images.thdstatic.com/catalog/pdfImages/3d/3d9e0673-ea6f-4a77-a599-9bddceaf49ec.pdf

A:  It's all about the pump. Make sure the pump is capable of an 8ft rise. I installed this basin in my basement same height with a longer run, works fine.

A:  I wouldn’t  Depending on amount of water entering pit pump would run longer also some pits water might have small particles that would plug inch line 

A:  Check with the pump manufacturer. I wouldn’t recommend downsizing the pump line, it will create extra pressure and can cause premature failure. 

A:  I belief the question is: Will the pump be strong enough really. Do some research on the pump "head". A back check valve would be suggested so the pump wouldn't have a 8' water in the pipe everytime it starts. Probably the back check valve would be 1 1/2" so I doubt you would have to reduce it. Install a long sweep 90 degree for the transition from up the wall to under the joist. You also should have a fall from the elbow to the drain (1/4" per foot) This is assuming drain is interior. That certainly would be easier with an unfinished ceiling. You should leave an air-gap to the drain, instead of stuffing it down that pipe. Have you considered an outdoor drain tile? It would probably be more finished looking, specially if you have finished ceilings. And would probably be a little less mess around where it goes in to the drain. Inside drainage would possibly not allowed to go into sewer in most municipalities. And you don't want to run it thru a septic tank.

A:  Hello Stephen. Thanks for the question. We think it best that you ask this question of the sump pump manufacturer as they will provide better guidance.

A:  Stay with 1.5 inch PVC, the 1 inch requires more pressure from the pump. I used 2 inch PVC for 100 ft, no problem.