Q:Will this fit a 1982 duracraft floor model drill press
by|Apr 19, 2020
1 Answer
Answer This Question
A: yes
by|Apr 20, 2020
Q:Will this fit s Craftsman 15 inch floor drill press?
by|Mar 7, 2020
4 Answers
Answer This Question
A: Yes no problem at all
by|Mar 8, 2020
A: It's possible. You still need a fixed, round anchor point to attach the bracket to.
by|Mar 9, 2020
A: Yes, it should work fine
by|Mar 9, 2020
A: Yes it will
by|Mar 8, 2020
Q:Will it fit on King KC-116FN (13 inches floor press-drill)? Thank you for the answer.
by|Jan 17, 2020
1 Answer
Answer This Question
A: Yes it should fit no problem. If you do find it a little loose when you mount it, a trick to do is do a couple wrps of electric tape around the drillpress collar to make it a little thicker. It does come with a few different rings to mount it,
by|Jan 18, 2020
Q:Will mortising kit fit a 10” drill press. If so how much room does it leave to work with.......
by|Dec 6, 2019
1 Answer
Answer This Question
A: Depends on which drill press it is. It does fit most presses with no problem. The work room it lves depends on the travel of you drill table so its hard to say for sure. But it leaves a fare amount of room. It won't reach far out into the piece.
by|Dec 9, 2019
Q:does this work with a R1500 Rigid with a 55mm quill
by|Oct 30, 2019
1 Answer
Answer This Question
A: Yes
by|Oct 31, 2019
Q:I have a Ryobi model DP103L 10" drill press with a 1 3/4" (41.2 mm) Chuck. Will this mortising ki...
by|Oct 18, 2019
1 Answer
Answer This Question
A: Yes
by|Oct 18, 2019
Q:Is the holder 5/8” or 3/4” shank
by|Jul 2, 2019
2 Answers
Answer This Question
A: Not sure what part you're talking about. The bit that goes in the chuck is 1/2"
by|Dec 2, 2019
A: The holder for chisel is 5/8 or 3/4
by|Jul 3, 2019
Q:will this fit rockwell 11-100
by|May 11, 2019
1 Answer
Answer This Question
A: Yes it should fit no problem.
by|Nov 14, 2022
Q:Will this fit the delta Shopmaster dp400 floor model
by|Feb 16, 2019
2 Answers
Answer This Question
A: No, this product is not compatible.
by|May 26, 2020
1 found this answer helpful
A: yes it will. if you do find it to be a little lose you could put a couple of wraps of electric tape around the yoke and just remove it when done.
by|Feb 20, 2019
Q:Will this fit the WEN 2412 Drill Press?
by|Nov 26, 2018
1 Answer
Answer This Question
A: Yes it will. If it's a little loose there's a trick you could do. Just do a couple wraps of tape to make up the difference