A: Mortising Attachment with Four Chisel and Bit Sets MODEL NUMBER: 17-924 will fit the 18-900L.
by|Apr 17, 2023
Q:will this fit my Wen bench drill press?
by|Mar 20, 2023
0 Answer
Answer This Question
Q:Will this work on a bench top drill press
by|Sep 20, 2020
1 Answer
Answer This Question
A: It depends on how small it is in refards to the amount of room in between the Chuck and table. But it does fit most of them. If the base of attachment is a little loose a couple wraps of tape will take up the difference so you could still tighten it
by|Jul 9, 2023
2 found this answer helpful
Q:Where can I find the users guide for this?. I lost mine some how.
by|Aug 14, 2020
1 Answer
Answer This Question
A: If you go to delta's website the user manuals are there in a PDF file you could download and then print out.
by|Jan 31, 2023
1 found this answer helpful
Q:Will this fit a Jet JDP-15M bench top drill press?
by|Aug 10, 2020
1 Answer
Answer This Question
A: Yes it should fit no problem. If it's lose at all around the shaft you could always do a wrap or two of electric tape.
by|Aug 15, 2020
Q:Will it work with a 1/2 in chuck
by|Jul 25, 2020
1 Answer
Answer This Question
A: It's hard to say it depends more on the drill press you want to use it on.
by|Jul 28, 2020
Q:Will this work with WEN 4210T drill press?
by|Jul 23, 2020
1 Answer
Answer This Question
A: Fits quill diameters of 66 mm, 50.8mm, 48 mm and 38 mm
by|Jul 24, 2020
Q:Will this kit work in Wen 4214. (55mm quill)?
by|Jun 5, 2020
1 Answer
Answer This Question
A: Yes it should work just fine on that model
by|Jun 12, 2020
Q:will this work on a Porter Cable drill press model PCB660DP
by|May 21, 2020
1 Answer
Answer This Question
A: It should work on it. I have heard that sometimes the casting is slight off and may require a wrap or two of ELECTRIC tape around the column a few times to take up a little space so you could tighten it down all the way
by|May 27, 2020
Q:will this work on a Porter Cable floor model PCB660DP drill press?