Customer Reviews for Duralux Marine Paint 1 qt. White Marine Enamel

Rating provided by a verified purchaser

Purchased to repaint water fountain. Worker well

very good product just wish it would be a little easier to clean

used this product to paint and revive old discolored fiberglass shower enclosure. Looks like new! Paint went on easily, one coat covered walls. How long it will last remains to be seen but for now, beautiful glossy white!

Impressed, great coverage and sheen

Looks good around the fiberglass edge of the pool where it was discolored. Goes on thick that eliminated vertical run. Waiting to see the durability with the sun and elements in the next coming months.

Performed as advertised. Coverage was amazing for white.

Rating provided by a verified purchaser

Rating provided by a verified purchaser

Didn't use the white yet but I did use the blue. It was on the bottom of the boat for more than 8 hours before it rained and seemed to wash off somewhat. I gave it a second coat and waiting to see how it fared out.

Good product

There were virtually no instructions for how to use the paint, on the can or on the website. It’s like, if you don’t know how to spray their paint then you have no business spraying their paint. I had the compressor set at 60-70 psi and the paint was splattering. Black same. Orange was great.

Great paint great price

Rating provided by a verified purchaser

Great thanks

great paint

The paint is easy to mix up with just a stir stick. It is very sticky but does not run very badly. Drys in about a day and is hard as nails. Since it is oil base you have to clean brushes with paint thinner. Should last a long time. I used it on a wood picnic table. God bless ya'll!

looks good on my boat

The paint worked great and was easy to work with.

Paint covered well the only complaint was color is lighter than sample on website,and has more gloss than expected.

The paint worked well for interior car restoration --a late 80's salvaged Jeep Cherokee after all plastic trim and accessories were removed. Heater core needed replaced, which required removing dash.. so good excuse to gut everything!). A coating of Zep Pro Rust Converter was applied first. Took more than a day to dry. I applied it a bit thick with brush.

Rating provided by a verified purchaser

Rating provided by a verified purchaser

Easy to apply; finish looks great. Applied to boat trailer; test will be when trailer is submerged into salt water.

Used this product on a very old 14’ alumacraft- sanded hull, decreased with acetone, and rolled it on. Very thick , awesome coverage- feels like a thick shell over the hull. Heavy paint odor while drying, but that’s to be expected I guess. Highly recommended.

High quality paint that adheres great to fiberglass.

I used this on sections of fiberglass radio antennas that had been outdoors for some time. Prepared the fiberglass and then applied paint. Allowed time to dry.Applied a second coat and allowed to dry. Checked antennas and reinstalled. Paint worked great.

Dry time was not good took 3 days to dry with a outside temp of 90 degrees paint separated had to mix for a hour

Beautiful colors, goes on easy. Shiny.

Worked a lot better than I hoped it would! Penetrated and sealed a poor quality surface very well.