Customer Reviews for DANCO 1-Handle Valve Trim Kit in Chrome for Delta Tub/Shower Faucets (Valve Not Included)

Ok, and easy to install. But it is plastic so quality is not as good as it could be.

Rating provided by a verified purchaser

The part did not fit on delta

No valve. Should have bought one with.

Easy to replace. High quality

Rating provided by a verified purchaser

Rating provided by a verified purchaser

We used these trim kits to upgrade our shower faucets and drains to brushed nickle. (instead of outdated gold) easy job and a nice look!

Rating provided by a verified purchaser

Had everything needed to make proper repairs.

Very pleased with final result.

Impossible to put in with our proper instructions

Returned, didn’t fit my shower

It is a nice finish product if it's my wall in it does

Cheap piece of plastic for $43. Don't buy it. I wish i would read reviews before shopping in the store

Works fine but the handle does not fit snug. There is play in it when turning it on.

The original screw for the delta faucet being removed where 3/16 of an inch longer than the screws provided. Wasted 20-30 minutes of my time trying to get the new screws to fit as they matched finish better, but had to settle on using old screws. So in an effort to save a penny or two in shorter screws, they have earned a 1 Star rating (hope the 2 cents was worth it, I would have been willing to pay more for the longer screws). The face plate insert did not snap into place, again, a little bit more material would have done the job. The gasket on outer ring does not have enough give to handle imperfections in the shower wall (had to either get another gasket or caulk the gap). Only good thing was that in spite of not being able to remove old value, the face plate and adaptor for handle did fit existing value. Finally, would be nice if they had a program to return or ship the unneeded parts so they could reuse them in another package (too much waste in this world already, so I will try to free cycle to local plumber).

Rating provided by a verified purchaser

It does not go flush to the wall because the inner part is about a quarter inch out from the bezel, so you have to cut a four inch diameter hole in your wall to make it work. It’s plastic and cheap looking once you get it out of the packaging.

Worked as it should looks great

This product looks more chrome than brushed nickel, the back plate is plastic and the handle wiggles despite being tightened down fully. When I tried to remove handle to adjust, found the hex bolt that attaches handle had seized, stripping the bolt head requiring me to drill out the handle to remove.

Rating provided by a verified purchaser

Would buy a different replacement in the future. Bad choice for a cramped shower stall as it is too easy to bump into and move the handle, causing the temperature of the water to dramatically change to either freezing cold or scalding hot during the shower.

This product just plain sucks. The only metal part is the handle and the screws. Everything else is CHEAP plastic and the front plate actually wont even stay clipped into itself once you have the foam gasket on. Returned and got the Delta 13/14 instead. Much better

Piece of crap. Cheap plastic and far from usable. Returned the next day.

Didn't have all components