Q:Are these doors able to be cut to fit a smaller opening?
by|Feb 27, 2022
5 Answers
Answer This Question
A: Unfortunately no . Unless you don’t mind the bottom of the doors flapping in the wind . The guide rollers are permanently attached
by|Mar 3, 2022
A: Not the actual doors but the frame yes. I trimmed the frame pieces to fit in my doorway.
by|Mar 2, 2022
A: No. Doors look nice enough, but are a thin facade over a rather flimsy wood frame that's open in the back.
by|Feb 28, 2022
A: These can’t be cut down however the doors bypass each other so the opening can be smaller.
They install in 15 minutes.
by|Aug 22, 2022
A: I don’t know. Someone installed them for me. The door material isn’t very thick so I suppose the doors could be cut.
by|Mar 7, 2022
Q:The doors I have and want to replace are 79x24 each. Could I use these doors with my old hardware? The rough opening is 81x47.
by|Jan 27, 2022
3 Answers
Answer This Question
A: Depends on the old hardware.
I had to remove old hardware, but new hardware was easy enough to install
by|Jan 31, 2022
A: Because of the way these doors hang, you must use the new hardware that comes with the sliding door.
by|Jun 4, 2022
A: No . The doors are pre installed with hardware
by|Jan 31, 2022
Q:What is the actual height of the door itself??
by|Jan 27, 2022
3 Answers
Answer This Question
A: 78 inches
by|Jul 6, 2022
2 found this answer helpful
A: It’s standard height. 80 inches.
by|Jul 6, 2022
1 found this answer helpful
A: 78 in is the physical door, but the hanger that goes on to the roller is two more inches, so you must allow for 80 in
by|Mar 25, 2023
1 found this answer helpful
Q:Sliding closet door
Does each door slide to the opposite side (e.g, one door goes in front of the other)?
by|Jan 5, 2022
5 Answers
Answer This Question
A: Yes. Both doors move
by|Jan 6, 2022
A: Yes
by|Jan 8, 2022
A: Yes
by|Jan 9, 2022
A: Yes and slides smoothly
by|Jan 9, 2022
A: Yes they bypass eachother
by|Jan 7, 2022
Q:Are you able to adjust the height of the doors to 79 inches
by|Dec 21, 2021
3 Answers
Answer This Question
A: No they have no backs they are hollow
by|Dec 26, 2021
A: Door can be custom fitted by cutting off the extra inches at the bottom.
by|Dec 26, 2021
A: Not sure if the mounting allows for it...but in the past I have trimmed doors down by cutting from the bottom as needed. Usually the hollow core has a 1.5" to 2" thick solid shim around the inside so it allows for trimming...just don't go too crazy...1" trim off the bottom should be safe... it's doable if you are a little bit handy. Hope this helps. Good luck!
by|Aug 13, 2022
1 found this answer helpful
Q:can these doors be cut to fit my length of 78"
by|Dec 6, 2021
1 Answer
Answer This Question
A: No the doors can't be cut. They have a steel frame around the edge. Home depot can special order the size you need.
by|Jun 5, 2023
Q:Is this price for one door? or two panels of door
by|Oct 24, 2021
1 Answer
Answer This Question
A: Dear Doors,
The TRUporte 48 in. x 80 in. 106 Series White Composite Interior Sliding Door comes with 2 doors. If you have any questions please call use to Speak to an Associate about Doors and Windows. Call 1-833-HDAPRON (432-7766) for free design, purchase and installation help daily from 9AM – 8PM EST.
by|Oct 24, 2021
Q:What is the finished sized of the opening needed?
by|Jul 27, 2021
1 Answer
Answer This Question
A: These doors should fit a finished opening of 48" wide x 80 1/8"-80 5/8" high.
by|Dec 8, 2023
1 found this answer helpful
Q:Do you come into homes to measure and install closet sliding doors for bedroom? Estimates?
by|Jul 3, 2021
1 Answer
Answer This Question
A: You would have to contact your local Home Depot to find out.
by|Oct 12, 2021
Q:Would it be possible for me to drill a pilot hole for a knob (I realize hardware is not needed for operation it would be easier for my smaller children to use a knob)? Would the material splinter when drilled?
by|Jun 28, 2021
1 Answer
Answer This Question
A: We don't advise adding any handles or knobs to these doors. If you do it will void the warranty.