Q:Greetings! Can this device be used on an Anderson storm door, series 3000? Thank you!
by|Feb 19, 2024
1 Answer
Answer This Question
A: Absolutely! You will want to install this in the same location as you would the Anderson door closer, but it should work great for that door.
by|Feb 28, 2024
Q:Is it warranted?
by|Feb 11, 2024
1 Answer
Answer This Question
A: Hi Misty, Yes. The Touch 'n Hold comes with a 2-Year limited warranty that covers any issues that arise as a result of a manufacturer's defect. It does not cover physical damage such as misuse or wind damage. Thanks for your question!
by|Feb 28, 2024
Q:Can this be used on a Anderson storm door?
by|Jan 15, 2024
1 Answer
Answer This Question
A: Hi Jenny, Thanks for the question. Generally, yes! These can be used as replacement closers or as upgrades for most Anderson doors. It depends a bit on the type of Anderson door your installing it on, but as long as the door is already equipped with a cylinder style closer, then using the Touch 'n Hold shouldn't be any problem. Most likely you won't even have to remove your old brackets (a lot of times you can just swap out the closers). But please follow the instructions to make sure the positioning of the brackets is correct to ensure the best experience.
by|Jan 22, 2024
Q:Is it quiet?
by|Oct 12, 2023
1 Answer
Answer This Question
A: Hi TamieJ, Yes. The Touch 'n Hold Smooth door closer is very quiet. Thanks!
by|Nov 7, 2023
Q:What is the length of the pneumatic tube?
by|Jun 6, 2023
2 Answers
Answer This Question
A: 14 inches
by|Jun 8, 2023
A: The cylinder length is 12 inches. The total length is longer, but the Touch 'n Hold matches the industry standard length for door closers.
by|Jun 8, 2023
Q:I want a genuine Greenstar Touch'n Hold. I couldn't tell by Home Depot's pics although older reviews show it's genuine. Is it still Greenstar brand? Thanks!
by|May 16, 2023
1 Answer
Answer This Question
A: Yes, this is a genuine Greenstar product
by|Sep 9, 2023
1 found this answer helpful
Q:Can this be used on the bottom of a Larson full glass door also while using the standard Larson door closer at the top of the door?
by|Feb 8, 2023
2 Answers
Answer This Question
A: No, the closers will most liekly not work in unison causing multiple issues.
Mike
by|Feb 10, 2023
A: Yep! That shouldn't cause any issues. However, to maximize the smooth closing function of the Touch 'n Hold door closer, it's best to go with the Touch 'n Hold Smooth Dual Kit and replace both the top an bottom closers.
by|May 16, 2023
2 found this answer helpful
Q:What hardware is included?
by|May 22, 2021
2 Answers
Answer This Question
A: Thanks for the question. All of our Touch n Hold kits come with 2 x brackets (door and jamb), and the screws and connector pins required for installation. All you'll need is a power drill for pre-drilling holes for installation into a new door.
by|May 24, 2021
A: Everything you need except tools. New brackets for door, both ends. Screws. Pins. Rubber rings to keep pin from slipping out. Diagram.