Q:Standard construction uses 16" centers for studs. Why do they not make these grab bars in multiples of 16 inches to match the spacing of the studs so they can be mounted securely?
by|Apr 8, 2024
1 Answer
Answer This Question
A: The 18” bar is for a vertical mount in a commercial setting. It is a requirement.
by|Apr 10, 2024
Q:How many Wing-it’s do I need per grab bar?
by|Apr 5, 2024
1 Answer
Answer This Question
A: Thank you. You will need two. The WingIts are sold in sets of two so you will need one pack for each grab bar.
by|Apr 8, 2024
Q:What is the standard or recommended height from the floor that a grab bar should be installed? (not a shower install)
by|Mar 15, 2024
1 Answer
Answer This Question
A: Thank you. According to the ADA, the correct height is 33 to 36 inches from the finished floor.
by|Mar 18, 2024
Q:Is it critical to hit studs when installing the screws through the tile? I’m not sure a stud finder can locate them through tile.
by|Mar 7, 2024
1 Answer
Answer This Question
A: Thank you. It is critical you either hit a stud or use the WingIts Stud-Less installation Kit.
Internet # 202552917
Model # RC-RESGBW35-2
Store SKU # 1005557118
Store SO SKU # 1000762707
by|Apr 20, 2024
2 found this answer helpful
Q:What is the diameter of bar where you are holding onto.
by|Feb 27, 2024
1 Answer
Answer This Question
A: Thank you. The bar is 1 1/4 inches.
by|Feb 28, 2024
Q:Is there a slip resistant coating on this grab bar
by|Feb 17, 2024
1 Answer
Answer This Question
A: Thank you. There is no slip resistant coating on the grab bar.
by|Feb 20, 2024
Q:Can I install this over ceramic tile?
by|Jan 15, 2024
1 Answer
Answer This Question
A: Thank you. You can install this on tile, but you will need a tile drill bit.
by|Mar 3, 2024
1 found this answer helpful
Q:How to put this on the ceramic wall in the bathtub area of the wall ??