Questions and Answers for Ekena Millwork 20 in. W x 20 in. H x 1/2 in. P Ashford Molded Classic Wainscot Wall Panel

A:  Thank you for your interest in our product. These are sold as individual panels, to ensure you can get as many panels as needed for your project. If you ordered 4 of them, they would come shipped together. Good luck on your project!

A:  Thank you for your interest in this product! This is a great question. The space between panels really just comes down to personal preference, how many panels you want, and the dimensions of your specific wall(s). Generally, these panels are spaced between 1" to 5" apart. Because of this, you might consider either six panels or five. If you go with six, the space between panels would be approximately 2.5". If you go with five, the space between panels would be approximately 6.33". This is slightly outside of the standard ranging but could definitely still work. You can play with the spacing a bit, so I would recommend marking your walls according to the quantity you think you would want and to the desired spacing before ordering. Best of luck on your project!

A:  No, this product does not offer an installation video.

A:  They come as a single unit with no seams at all as they are molded. You just pop it on the wall and that's it.

A:  No I have never seen a video.

A:  I don’t know if Home Depot has a video ( I suspect not). There is no assembly the product comes complete as shown. All you need do is nail it in place and paint.

A:  These are not actual picture frames, this is a panel molding that is open and meant to be installed into a wall.

A:  The inside measurement is 16.75 inches by 16.75 inches. The back is flat so I don’t know how you would secure it to the canvas. Also the wainscot is a light foam construction not much strength to hold the canvas tight.

A:  These are designed to give the illusion that they are panels. The product itself is a frame, and the wall itself would be the "panel". We have over 50 prefabricated options available and any of our 200+ chair rail molding profiles can be cut to make these types of panels on site.

A:  This listing is for a solid wall panel.

A:  The product comes with a primer base coat ready for a finishing top coat. A good quality exterior or latex or oil base paint is recommended.The surface must be clean, dry, and free from greases or waxes before finishing.

A:  These panels should be back in stock mid to late May unfortunately.