Questions and Answers for DEWALT 165 ft. Red Self-Leveling Cross-Line Laser Level with (3) AA Batteries & Case

A:  Hello Zooby Thank you for your contact. We apologize for any trouble or inconvenience in finding information. This laser level would not work in an angled state. Best Regards Sherri C DEWALT

A:  Yes

A:  Hello, no this only has 2 straight lines, 1 horizontally and 1 vertically, it cannot be angled

A:  There should be a tripod you can get for it.

A:  Hello Kevin Thank you for your contact. We apologize for any trouble or inconvenience in finding information. There is not an adapter to use this cross-line laser level with a 5/8"-11 thread on a tripod. Best Regards Sherri C DEWALT

A:  Hello R_neck7, Yes, this will level both vertical and horizontal so it will level a mobile home. Thank you DEWALT

A:  Hello Jay Thank you for your contact. We apologize for any trouble or inconvenience in finding information. The DW087 and DW088 LaserChalkLine™ Laser Line Generators are Class II laser products and comply with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to laser notice No. 50, dated June 24, 2007. If there is an issue with the laser, it would be a repair situation. Internal parts are not made available and it is not advised to open the laser. If there are additional questions, please reach out to DEWALT directly. Best Regards Sherri C DEWALT

A:  It does not work on sunny days! It will work in shade or early mornings!

A:  Not very good in direct sunlight like at the height of the afternoon sun. Much better in more shaded area's or time of day.

A:  The only time I have ever used a red laser outside was in a low light conditions.

A:  You can only get a level and plumb line. Laser will not point straight up, e.g. a point from floor to ceiling.

A:  There are two buttons on the side of the laser. one goes horizontal and the other goes vertical. You just choose the way you want to level. Or both.

A:  Yes this will work with your type tripod. I have been using mine on a camera tripod since getting it.

A:  The DW088K-QU has a 1/4" thread base and any 1/4" tripod will work.

A:  Yes

A:  When trying to get Laser level magnet to hold to the drywall wall corner bead, keep hands close to the laser level until the magnums actually grab. Laser may fall into your hands a couple of times, depending on the corner bead. This laser is light enough there shouldn’t be a problem grabbing. This DeWalt laser doesn’t do well shooting down at close range. Horizon is fine at any range. If one wants to shoot the vertical laser on a stud, then the laser has to be perpendicular to the TV wall. Metal door jams work great. If you have a camera tripod use that, put the tripod in a small table to elevate it if you have to.