Customer Reviews for E-Z Ancor Toggle-Lock 100 lbs. 2-1/2 in. Philips Zinc-Plated Alloy Flat-Head Self-Drilling Drywall Screws Anchors (2-Pack)

Anchors don't open and if they do (rarely) they don't fully open. These anchors destroyed my drywall. I went through two anchors and gave up and had to end up looking for wall studs. Now I have a whole new project repairing my wall. This product is a waste of money and I dont exactly know how the return policy works ,but I hope I can still return them.

Holding up a 52 inch circular 40 lb mirror perfectly on hollow wall.

Product broke while trying to use it. I will be returning these to the store for a refund

Horrible. The screw jams against the toggle, not allowing it to engage. Stick to regular toggle anchors.

I love these...My primary use is for hanging TVs in metal studs. pre-drill first and not with swivel mounts. I have had a few over of the toggles over the last few boxes give me issues and i end up having to spend a lot of time to swap them. Otherwise they are great.

Good for drywall anchors. If you have metal studs, these do a great job anywhere along your wall.

This anchor was amazing… It was very easy to install and it seemed to be very durable to hang many things. We installed for towel rack that my son kept pulling hard, and original anchor just came loose. Let’s see if it will get loose or not.

The anchor bolt screwed into the wall was defective. I could not fully insert the screw into the anchor bolt even though it was fully anchored to the wall. I’m lucky we had an alternate set of holes we could set for the anchors (which I used another product for) so the project could still be completed. Bad product, do not recommend!!!

The Ez-Accor's worked better than expected. I will recommend them everyone who is in need. Very good product.

I followed the directions and it worked perfectly just as advertised. My towel bar is secured nicely to the bathroom wall.

Only a few anchors would even engage. They did nothing but leave large holes in the wall.

These toggles have a high failure rate to catch and engage the lock. The bolt tends to get stuck on the metal and break if you try to mussel it. My pack of ten had a 3/10 success rate.

Great product. Easy to use

The anchor didn’t get tight at all. Had to patch the hole and buy a different anchor, which worked fine. Waste of money and wish I could return it.

We needed to mount a projector on our ceiling and I didn't want to cut into it to add a support beam or screw in a piece of wood spanning two joists. I have used E-Z Ancor Twist-N-Lock drywall studs/anchors before and they were pretty solid. Unfortunately this product does not work nearly as well. Anchor struggled to cut through, COMPLETELY wrecked the surface of the sheetrock with its clunky thread, then fell apart when trying to thread the screw in. Total waste of time and unnecessary damage.

Had a learning experience when installing in sheet rock wall... don't put screw into hollow-wall anchor , and set the anchor until you have inserted screw through the bracket you are hanging.... The anchor is very well made and works great,

Just what we needed for hanging cupboards.

These Drywall Anchors were perfect for installation of handicap bars. The installation was easy. The weight rating provides assurance for extended use.

Very good held way better than the cheap plastic ones. Used it for an extra support bracket for my garage door opener. There didn’t seem to be a stud I could find.

This product did exactly what I needed them to do. I would recommend it and will be buying again in the future!

Chewed up older drywall pretty good on the last 1/2 turn requiring some patching. But holds very well