Questions and Answers for SentrySafe Biometric Gun Safe for 1 Pistol with Fingerprint Lock and Interior Lights

A:  This is not promoted to meet TSA Standards. Please check what the TSA requirements are for gun safety to be sure. Sorry for any inconvenience. Sentry Safe Customer Service

A:  If you experience challenges with any parts on SentrySafe products, they are backed by a limited 1 year manufacturers warranty. Just call us.

A:  Yes - two for the main user, and two more for a backup user

A:  Yes

A:  Yes, there are holes on the back for hanging up vertically. It would be difficult to hang upside-down but not impossible.

A:  It comes with mounting hardware and can mount to whatever you want however there is nothing to secure the gun in the safe and if mounted upside down under a table, the gun would fall freely upon opening the safe.

A:  no, opens from the top so it would be upside down

A:  Yes, this safe can be mounted under a table and the hardware is included.

A:  safe can be mounted and comes with screws to facilitate. I do not believe it could be mounted under a bedside table because it pops opens from the top,

A:  Only if there is a shelf so the safe can sit on it. This would permit access to the buttons, finger detection or key entries. I guess you could mount it upside down, but you would need to open it using your finger turned up as well as use your other hand to catch the gun. I don't know of any mechanical reasons why it couldn't.

A:  I would not suggest that, as the top opens and the gun would just fall. It is designed to be wall mounted

A:  Depends on the type of table. It comes with 2 lag screws and 2 washers. You will need a drill, wrench, a 9/32" drill bit for attaching to wood. It is intended to be mounted with a horizontal orientation. The safe has pre-drilled holes on the bottom which you would need to line up with the area where you want to mount it.

A:  Very easy. Open the safe, and there is a little panel that pops of that exposes the programming buttons and battery. Difficulty 1/5.

A:  It is pretty easy, the batteries is in a holder stored under the buttons.

A:  This gun safe comes with an override key so you can access the safe to change the batteries on the inside. There is battery cover that needs to be removed and then the batteries are exposed so they can be changed.

A:  very easy, you need the key to open once the batteries wear out but once inside the safe it takes two minutes

A:  It is very easy. A panel opens in side to install the batteries.

A:  Plenty of space for prescription stuff.

A:  Didn’t work correctly door would not pop open returned it to the store don’t waste your time go online buy a vault tek

A:  yes you can get a lot of prescription containers in the safe. its great if you have young kids running around. now you can keep them safe. for you its easy to get your prescription with one finger or a code you put in.

A:  Yes you can store anything that fits. Mine holds a Taurus 709 slim and a Springfield XD subcompact with 2 clips.

A:  Press a button, set combo, press button again, done.

A:  This safe is actually quite easy to program but you must follow the instructions closely.

A:  average

A:  It has been a while since I did it, but as I recall, it was a snap. The fingerprint was easy. You had to place your finger on the reader a few times to get it to recognize your fingerprint and the number code (second way to lock/unlock) was just as easy. It is a great safe. I wouldn't let programming it deter you.

A:  It is not difficult.

A:  This weighs 11.9 lbs.

A:  It weighs 11.9 pounds.

A:  12 lbs