Questions and Answers for Rust-Oleum Porch and Floor 1- Gal. Dove Gray Anti-Skid Satin 50 VOC Exterior Solid Stain (2-Pack)

A:  Glad to help out, Aimee. You can certainly add decorative flecks to the Rust-Oleum Porch & Floor Coating, which is be applied to wood surfaces and is excellent for a covered patio. - Rust-Oleum Product Support 5

A:  We appreciate your interest, Andy! The Rust-Oleum Porch & Floor Coating is suitable for use on wood and concrete surfaces. We don't recommend applying it to fiberglass because it will not adhere properly. Instead, we recommend using Rust-Oleum Marine Coatings Topside Paint, which can be applied to fiberglass. https://www.homedepot.com/s/marine%2520topside?NCNI-5 - Rust-Oleum Product Support 5

A:  Yes, this paint can be tinted.

A:  Yes, Rust-Oleum Porch and Floor Coating Tint Base can be tinted up to several different pastel colors.

A:  Thank you for reaching out, Phyllis! Rust-Oleum Porch and Floor Coating Paint is an oil-modified acrylic paint designed to provide excellent color retention, adhesion and protection against UV rays, water damage, and mildew on both wood and concrete surfaces. This coating ensures a safe, slip-free surface and doesn't require any additional anti-skid additives.

A:  Rust-Oleum Porch and Floor Anti-Skid Coating is only recommended for use over wood or concrete. This product will be unable to properly adhere to a fiberglass surface.

A:  John, our 1-gal. Dove Gray Anti-Skid Satin 50 VOC Coating should work on some concrete surfaces that have aggregate added, however, some heavy aggregate surfaces may be too non-porous to provide good adhesion.

A:  Great question, Trent! Yes, our 1-gal. Dove Gray Anti-Skid Satin 50 VOC Coating can be applied over this coating. Make sure that all loose or peeling epoxy has been removed, and it is a good idea to scuff-sand the surface prior to cleaning to ensure good adhesion to the surface.

A:  Yes, our Dove Gray Anti-Skid Satin 50 VOC Coating can be used on your boat deck. We recommend removing any adhesive used for the carpet, and the wood should be lightly sanded with 50 grit sandpaper then cleaned to ensure the coating will adhere well to the surface. Allow the coating to dry for at least 72 hours prior to putting the boat back on the water.

A:  Apply with a high quality nylon/polyester bristle brush, short nap paint/stain pad or roller or an airless sprayer (do not use a pump sprayer). Brushing is the preferred method, especially for rough sawn wood. When rolling or spraying, make sure to back-brush along the grain. This will eliminate any drips, runs, uneven coverage or surface puddles. To minimize lap marks maintain a wet edge. If using more than one gallon, intermix all cans of the same product to ensure color uniformity

A:  Thank you for reaching out, Drew! For the best results, we recommend applying Rust-Oleum Porch and Floor Coating with a high-quality nylon/polyester bristle brush, short nap paint/stain pad or roller or an airless sprayer. Brushing is the preferred method, and it is essential to maintain a wet edge to help ensure an even finish.

A:  Great question! Rust-Oleum coatings, including Rust-Oleum Porch and Floor Coating, are unleaded and safe for use on toys and furniture.The cautions on the cans refer to the liquid form of the paint and are driven by the solvents in the paint. Once the paint is fully cured, the solvents have evaporated and are no longer in the coating; the remaining coating is a combination of solids made of pigments and additives bound by the resin and can be considered non-hazardous. This product is suitable for use on interior wood and concrete floor surfaces!