Questions and Answers for Glasliner 4 ft. x 8 ft. White .090 FRP Wall Board

A:  Hello Wall, please contact your local Home Depot store or customer service to clear items in your cart. Thank you, Stabilit America

A:  de[ends , if you want for a shower or any wet place , I say not ,

A:  Hello Fred, Yes, You can use nylon rivets (sold in store next to the panels) for installing the panels. Be sure to predrill the holes for the rivets. The recommended way to install is to use FRP adhesive. Thank you, -Stabilit America

A:  Hello Kris, The finish is designed to be a non‐adherable surface. If painting is necessary, a high-quality epoxy or acrylic‐based paint is suggested. Thanks, -Stabilit America

A:  Yes , but you need a special primer

A:  Hello Wonder, To keep it as clean as possible, we recommend washing the panels with a light detergent. The panels may also be cleaned with steam, high pressure sprayers, or soap and water. We strongly advise against using abrasive cleaners on panels to avoid scratching or scraping the surface. Hope this helps! -Stabilit America

A:  home depot has something like goo off

A:  yes , is water proof , easy to clean , just no close too heat

A:  Hello Robert, FRP panels would be great to use on the inside of a food truck. But do not put them directly behind a stove or any other area that would be exposed to high temperatures. The panels will warp and burn. Thank you, -Stabilit America

A:  yes , but you need seal all corner with silicon

A:  Hello Darryl, Yes, these panels can be used for shower walls. As long as the joints are sealed with a silicone caulk then you should be good to go. Thanks, -Stabilit America

A:  Hello FDquestion, The panels we sell in Home Depot stores are rated as a Class - C, general purpose panel. FRP will withstand temperature extremes of –65°F to +212°F. It will however, expand or contract with temperature variations. We do offer a Class - A, fire retardant panel through Home Depot's Special Order program. Thank you, -Stabilit America

A:  anione is ok , just used the right glue

A:  any is ok , just found the rick glue

A:  Hello Gary, If installing the FRP panels by adhesive, it is recommended the backing be a porous surface, such as concrete block, drywall, plywood or plaster walls. Thank you, -Stabilit America

A:  Hi, Yes, you can absolutely use this as a wall covering in a garage. It can be used in any indoor wall application. Thank you, -Stabilit America

A:  Hello David, The textured finish of the panel has a top coating meant to resist adhesion. Titebond solvent based adhesive might do the trick. It might be best to use plastic rivets. Just be sure to drill pilot holes. Thank you, - Stabilit America