Questions and Answers for Lithonia Lighting 40-Watt 4 ft. White Integrated LED Flush Mount Light

A:  2700K is consider as worm white

A:  For effective result use with non-dimmable switches. https://img.acuitybrands.com/public-assets/catalog/886484/fmlwl.pdf?abl_version=10%2f08%2f2019+21:37:23&DOC_Type=SPEC_SHEET

A:  Yes. https://img.acuitybrands.com/public-assets/catalog/886484/fmlwl.pdf?abl_version=10%2f08%2f2019+21:37:23&DOC_Type=SPEC_SHEET

A:  Hi maui, yes you can butt the plastic end caps together, but you can't without using the plastic end caps

A:  Each lamp has a conventional two-prong plug. No hard-wiring required. In addition, accessory approximately 2.5-ft cords and 2-inch connectors allow two or more lamps to be connected in series; with either (a) about 2.5-ft end-to-end separation, or (b) essentially adjacent ends for highly concentrated lighting. In this series configuration, pulling the on/off dangling cord activates ALL lamps in the series. I suggest examination of the Livonia web site for the availability of replacement lamp-to-lamp connection cords.

A:  Hi Andrew they are hardwired

A:  This fixture is hard-wired.

A:  Yes. The bulbs are factory installed and covered with a factory-installed diffuser

A:  Hi Lisa is no light bulbs has an LED strip so when you et fixture is all set just needs power

A:  The LED light strip is integrated meaning that it is part of the fixture, as delivered.

A:  Yes, the fixture includes the LED lighting.

A:  Yes , the LEDs are built in to fixture and puts out very good light .

A:  Hi Bo4865 Yes I wire all light fixtures by hard wiring them

A:  Yes. See Livonia diagram at https://lithonia.acuitybrands.com/products/detail/585687/Lithonia-Lighting/UCEL-Undercabinet/-/media/products/Lithonia_Lighting/585687/document/LL_3074_Resi_Undercabinet_Brochure_0516_pdf.pdf?DOC_Type=Brochures

A:  If you mean hooking power direct to fixture and not having a switch to turn it off ,yes you can , but fixture does not have a switch built in to turn it on and off and obviously the fixture would be on all the time as long as it has power .

A:  Well rt it depends on breaker size 15 amp breaker use #14/2 and if 20 amp breaker need #12/2 wire

A:  Check your local electrical code to determine the size needed.

A:  Since six of them will consume only about 240 watts or 2 amps at 120 volts, 15-gage wire would be adequate.

A:  Not being an electrician, I can only give my opinion, and I would recommend asking an electrician before doing this. If you are using a 15 amp circuit, I would not use smaller than awg14.

A:  The included instruction sheet says it is not to be used on a dimmer switch or circuit.

A:  No.

A:  Thank you for your email. No, this fixture cannot be used with a dimmer.

A:  I think you could use it, but I would use a light with 4000k brightness on the light spectrum in a garage and something close to 4000 Lumens. Keep in mind this light fixture's wires are external and are located in the center. If you are replacing a fluorescent light as I did, they can be wired at either end or in the center. The wires typically come straight out of the wall and go into the light fixture itself. If those wires are located at one end of the light fixture you may have to relocate the wires and then you will have to install a box that goes into the ceiling. If the wiring is an issue and you don't want to deal with it you can use the following LED light from Home Depot Lithonia 4 ft. 41-Watt White Integrated LED Low Profile Wraparound Flushmount Internet #203839057 Store SKU #1000001686. I ended up using this light fixture in my closet because I didn't want to deal with the wiring issue. I do prefer the look of the smaller, newer light you are looking at.

A:  Yes, It is rated for damp locations and well protected from dust and bugs.

A:  You can but it won't function properly if you live in parts of the country which have colder climates.