Q:Will this cut the aluminum edge? https://www.homedepot.com/p/Crescent-Wiss-9-3-4-in-Compound-Action-Straight-Left-and-Right-Cut-Aviation-Snips-M3R/100065942?source=shoppingads&locale=en-US&pla&utm_source=google&utm_medium=vantage&utm_campaign=24156&utm_co
by|May 15, 2024
1 Answer
Answer This Question
A: Hi Ally, Thank you for reaching out to us. Yes a new or freshly sharpened pair of tin snips can cut the sections. You can cut the front rail first then the dog leg which is a piece of the extrusion that butts up against the inside of the front lip of the gutter then cut the back aluminum rail then snap the section in two and trim the mesh.
by|May 16, 2024
Q:Are the screws stainless steel? Or are they plated/coated?
by|May 3, 2024
1 Answer
Answer This Question
A: Hi JJCC! The self-tapping screws are carbon steel self-tapping screws with a dacromet coating.
by|May 10, 2024
Q:Would it work on Tile roof if I can't snug it under like it is recommended to do on shingles?
by|May 3, 2024
1 Answer
Answer This Question
A: Hi Kash! In cases where you cannot slide the gutter guards underneath the roof, we recommend you use the bending method, where you need to bend the mesh up or down and screw through the mesh and into the drip edge, fascia or back of the gutter. You can also check out the installation videos here for your reference https://www.gutterguard.com/how-to-install-stainless-steel/. You are welcome to contact us at 877-662-5644 if you have any further questions.
by|May 6, 2024
Q:does 3m tape hold good
by|May 3, 2024
1 Answer
Answer This Question
A: Hi Nels, The 3M tape install method is very durable when applied properly. We do not have a specific time frame regarding how long the tape last but it is very high bond adhesive tape similar to the one used by auto mobile manufacturer to stick their logo on a car.
by|May 10, 2024
Q:Down to what micron size particle does this filter out?
by|May 2, 2024
1 Answer
Answer This Question
A: Hi Erik! The hole size in our Stainless-Steel Micro-Mesh Gutter Guard is 550 microns.
by|May 3, 2024
Q:Does it install without going under the first single
by|Apr 30, 2024
1 Answer
Answer This Question
A: Hi Chuck! The recommended installation is to slide the gutter guards under the last layer of shingle and on top of the underlayment.
by|Apr 30, 2024
Q:tried to install these filters today and the self taping screws don't self tap AT ALL. they just spin and then going flying to the ground lost in the grass below!
by|Apr 23, 2024
1 Answer
Answer This Question
A: Hi Bert! We appreciate you reacahing out to and sorry if the screws are giving you a hard time. You can also pre-drill if the self-tapping screws do not work. Feel free to call us at 877-662-5644 if you want us to send you some more screws.
by|Apr 24, 2024
Q:I already have rain water diverters on the gutters. Can this be installed them still in use?
by|Apr 23, 2024
1 Answer
Answer This Question
A: Hi Jason! You can use the rainwater diverter together with our gutter guards,. It is recommended that you remove it first, then reinstall it once the gutter guards have been installed.