A: Yes, this fasteners will work with Ridgid R138HPA.
by|Jul 17, 2023
Q:can these pin nails be used in a porter cable pin nailer?
by|May 5, 2022
1 Answer
Answer This Question
A: As long as it is a Porter Cable - PIN100 - 23 GA nailer it should work.
by|May 5, 2022
Q:Will these work in my Ryobi 23 ga pin nailer.
by|Nov 16, 2020
1 Answer
Answer This Question
A: yes, this product should work in your Ryobi nailer
by|Nov 17, 2020
1 found this answer helpful
Q:will these work in Ryobi 18-Volt ONE+ Cordless AirStrike 23-Gauge 1-3/8 in. Headless Pin Nailer ?
1-3/16 in. x 23-Gauge Micro Pins (3000-Count)
Q
by|Dec 3, 2018
1 Answer
Answer This Question
A: Yes, Grip-Rite GR1316PIN 1-3/16 in. x 23-Gauge Micro Pins (3000-Count) will work with Ryobi 18-Volt ONE+ Cordless AirStrike 23-Gauge 1-3/8 in. Headless Pin Nailer.
by|Jun 2, 2023
2 found this answer helpful
Q:Will these fit my Husky brand micro pinner? Bought pinner last year.
by|Apr 21, 2017
1 Answer
Answer This Question
A: They will most likely fit. However, since we cannot be sure of the pin nailer you are using make the the gauge of the Husky pin nailer is 23 gauge.The gauge of the nails and the pin nailer must match.
by|May 4, 2023
Q:What is the finish (eg, bright, galvanized)
by|Jan 14, 2017
1 Answer
Answer This Question
A: It's a bright finish, for indoor use only.
by|May 4, 2023
Q:can I use this nails with Porter-Cable BN125A nailer?
by|Apr 14, 2016
1 Answer
Answer This Question
A: These 23 gauge micro-pins will not work with your nailer. Please check the manufacturers specs, as this nailer looks like it shoots 18-gauge nails rather than 23 gauge. If your guide does confirm this, we would recommend that you use a product such as linked below;
http://www.homedepot.com/p/Grip-Rite-1-in-18-Gauge-Finish-Brad-Nail-5-000-Pack-GRF181/204718141
Thank you for your question and have a great day!
by|May 3, 2023
Q:does the arrow on 23-gauge micro pints face inward or outward from the pin nailer?
by|Oct 25, 2014
1 Answer
Answer This Question
A: The arrows face out through the loader, so that you can tell which way they need to be loaded into your finish nailer. Thanks for your question, and have a great day!