Questions and Answers for Frigidaire 2.0 cu. ft. Microwave in Stainless Steel, Built-In Capable with Sensor Cooking

A:  Ours is inset into cabinetry, not over the stove top.

A:  Hi, Lou. This model is designed to be built in, so it does not come with a mounting kit to install over the range and attached to a cabinet. We recommend installing it inside a cabinet with the included exhaust duct assembly. ~ Brandi

A:  We bought the recommended trim kit...30 in. and it looks nice.

A:  Hi, Reena! The minimum width requirement for the cut-out opening is 24-3/4". The size of the trim kit would depend on your preference and whether or not you are installing above an oven. If you are, you would want to match it to the size of the width of your oven. ~ Brandi

A:  You could try going to the Frigidaire website and click on the service or support tabs. They should be able to provide you with a list of appliance repair professionals authorized for warranty service in your area. if your unit is out of warranty, you could simply check your local listings for appliance repair and check their ratings to find a good service repair technician. These service repair facilities tend to be a little less expensive than going through the factory authorized warranty service technicians.

A:  I am sorry to hear you are having this issue, DeadMicrowave! Check the breaker to sure it did not trip the circuit. If that does not appear to be the issue, flip the breaker off for 2-3 minutes to reset the appliance. If it still does not come on, you can find a service provider by calling 1-888-203-1389 M-F from 8a-8p or Sat from 9a-6p EST. ~ Brandi

A:  Hey, bob. The available trim kits for this model microwave are below: -30" Stainless Steel Trim Kit – (PN # MWTK30KF) -27" Stainless Steel Trim Kit – (PN # MWTK27KF) -30" White Trim Kit – (PN # MWTK30KW) -27" White Trim Kit – (PN # MWTK27KW) -30" Black Trim Kit – (PN # MWTK30KB) -27" Black Trim Kit – (PN # MWTK27KB) Hope this helps! –Alexis

A:  Hi, Larry! When used in combination with another Frigidaire built-in product, a minimum clearance of 2 7/8" required from bottom of built-in Microwave cutout to top edge of companion product's face-plate, leaving a 2" visible gap between both product face-plates. ~Briana

A:  No, this model requires a 20'' depth.

A:  This unit has a built-in trim kit but alternate kits MWTK27KF and MWTK30KF are also available.

A:  Hi Mammajamma! Thank you for your inquiry. To have the built in look, it will require a trim kit. We hope this helps. -Thanks!-

A:  This trim kit is works with Frigidaire model FGMO205KB. The trim kit is designed to cover the hole in the cabinet in which the microwave sits. The 27" kit will cover a hole up to 27" wide. If the hole is wider than 27", you will need the 30" kit. If you're not buying the Frigidaire model FGMO205KB microwave and trying to match a microwave that is 27 3/4" wide, these won't work.

A:  Hi, SueBell. Thanks for reaching out. It does appear based on the dimension you provided, you may need a 30” trim kit. I strongly recommend reaching out to your local Home Depot for further assistance. Hope this helps. Should you have any additional questions, our team will be happy to assist you further at 888 203 1389. We are available Monday through Friday from 8am-8pm EST and Saturday from 9am-6pm EST. Regards-Derrick