Questions and Answers for Everlast PowerUltra 206PI TIG / Stick / Plasma Welder

A:  you don*t need separate adapter. see previous community answers, they are correct.

A:  It uses the same connection in the back for your Tig gas or compressed air for plasma. You can either remove one hose and connect the other when needed. Or do what I did. I put a T-fitting in the Tig gas line and added a shut off going to the Tig gas and one going to the compressed air connection. I use both a lot and I can switch between them in less then a minute now.

A:  Was delivered on time. Works great so far. Plasma works. Stick welds. Have not used tig side yet.

A:  Most compressor should come with an airflow regulator already, if not you'll want to get one. Also a inline oil and purity filter from your local hardware. You dont want moisture and oil flowing into your unit.

A:  The 206pi is the newer variance of the 205.

A:  The model is PowerUltra 206Pi

A:  You will get the latest model, PowerUltra 206Pi.

A:  HF - It comes with a foot pedal and remote start. Very nice setup.

A:  HF only.

A:  High frequency only.

A:  2019

A:  2018 year model

A:  Now, it is 2019.

A:  Power cord is 10ft

A:  About 5 1/2 feet for the 240 volt cord and the 120 adapter is another 1 foot long.

A:  should be ~5-6 ft.

A:  Please contact Everlast customer service at (877) 755-9353 to check on availability

A:  should be in-stock before christmas.

A:  should be in-stock before christmas.

A:  This is a back ordered item and will be available on May 1st.

A:  schedule shows mid march.