Questions and Answers for Everlast 200 Amp Power i-TIG 201 IGBT Digital Inverter DC Stick/TIG Welder with High Frequency and Lift TIG Start, 120V/240V

A:  homedepot stores do NOT physically have these welders in stock. you place an order online, and everlastwelders ships it to your address, or to homedepot store near you, so you can do in-store pick-up. thank you.

A:  yes, all our welder models are designed to work with european voltage standard. they automatically adjust for 50Hz/60Hz frequency.

A:  35% at 200 amps, 60% at 160 amps, 100% at 130 amps. this are TIG specs, based of 220v input.

A:  no, it*s limited to 6011. for 6010, look into PowerArc series, PowerArc200ST, PowerArc300ST or PowerArc280STH.

A:  this welder is single phase. it*s also a dual voltage, too. can either run of 120v or 240v input.

A:  no, this is a DC TIG welder. for alum you need AC/DC TIG. look into our PowerTIG 185DV or PowerTIG200DV models.

A:  no its dc only

A:  No, you need AC for aluminum

A:  regulator, yes. foot pedal is optional, you have to buy it separately.

A:  Welder, 230 to 110 cord adapter, stick holder, torch with finger switch, ground cable, assorted cups, collettes, regulator with flow meter, hose for argon to back of welder. No Foot pedal. no electrodes.

A:  standard package includes the following: 26 series TIG torch, 15 ft, with consumables starter pack (tangsten not included), ground clamp, stick holder, argon regulator, air hose, and pigtail adapter.

A:  You can get foot pedals from SSC Controls. They make after market pedals that are US made and are an upgrade for the machine.