Questions and Answers for Earlex Spray Station 1900 HVLP Paint Sprayer

A:  If you are asking if you can paint an SUV with this sprayer, yes you can. If you are expecting a factory finish, this is not the right sprayer for your project. You're welcome to contact technical support for a discussion at 800-328-8251

A:  Use of the product is solely at the purchaser's discretion.

A:  No

A:  The 1900 has a 1 quart container.

A:  It will. As long as you clean it each day, rinse with water to remove the lacquer thinner and allow it to dry before storage.

A:  Worked beautifully with a latex paint. The paint did have to be thinned a bit to spray really well. I think it would depend the the viscosity of the laquer

A:  If you mean a thick sealer like DryLok, no it cannot spray material that thick. It can spray regular latex paint that is thinned about 20% with water. For more answers contact us at 800-328-8251.

A:  Chalk paint shouldn't be strained but it should be thinned about 30-40% to spray with the 1900.

A:  Don't think the type of paint matters, it is the thickness of the paint. Instructions are very specific on how the paint should be. It even came with a funnel so you could time how long it took the paint to run through the opening at the bottom. Even thinned, the paint still covered very well. I did use a high quality Sherwin Williams paint with the primer already in it.

A:  You can, but our more powerful sprayers will work even better. Look at our 2901, 5500 and 6003. Or call us technical support at 800-328-8251.

A:  It can, but it may need to be strained or thinned before spraying. Contact technical support at 800-328-8251 for a discussion about it.

A:  Yes, this sprayer can be used with stain.

A:  Yes, this spray kit that can be used with several different spray mediums including varnishes,wood preservatives, enamels, oil and water based paints and automotive paints. To clean it you empty it out and then use thinner to spray and clean the inside as well.

A:  You can spray any liquid you want with the 1900, depending on thickness. Clean it up by using the thinner for the material you were just spraying. There is no need to go to a harsher chemical for cleaning. We're happy to help at 800-328-8251.

A:  This can only be used at up to a 45 degree angle. Tipping the unit more than this can damage the motor.

A:  This sprayer can be held in an up position in order to paint ceilings and such. I'll call it 89 degrees, just shy of 90. For a more detailed discussion give us a call at 800-328-8251.

A:  For a factory automotive finish this is not the tool. It will spray latex and oil paints and lacquers. I comes with a 2.0mm needle and you can get a 1.5 or even a 1.0mm for finer finishing. We have many sprayers capable of spraying automotive finishes, give us a call at 800-328-8251 to discuss further.

A:  From our experience it is a little spluttery... We sprayed some interior and exterior doors. It does seem to splatter a bit..