Questions and Answers for DuraVent PelletVent 3 in. x 60 in. Double-Wall Chimney Stove Pipe

A:  As many as the stove manufacturer allows.

A:  Twist lock

A:  I would not use this on a wood stove. Pellet stoves run about 300 degrees but wood burners can run up to 800 degrees. You should use a triple wall pipe.

A:  That is exactly what this pipe is for

A:  No, this is designed for pellet stoves only. Please contact the wood stove manufacturer for proper venting procedures, practices and required venting.

A:  This question needs to be answered by the appliance manufacturer, as they carry the onus for venting.

A:  you can take a 90 degree elbow and use this to straighten out your run. Simply twist and turn until the desired change is accomplished. Remember to follow your local building and fire codes in your installation.

A:  As the venting manufacturer, we cannot offer installation information, being that we only test to safety standards set out by UL. All installation questions need to be directed to the appliance manufacturer, they test to install standards, so they would be the authority and have the distances to combustibles. Please contact the appliance manufacturer for proper installation practices for venting. Also, being it is below grade, we suggest that you contact your local code officials for clarification on these types of installations.

A:  I enclosed mine with Hardibacker concrete board. Approximately 1.5 inches from the pipe. Pipe gets a little warm but absolutely no heat comes from the other side of the hardy backer.

A:  yes and no all you need is gas vet tube doubled wall this is for pellet or corn stoves its doubled walled but has a stainless liner witch makes it it expensive so just find the double wall gas vent tube it would be over kill for gas vent line

A:  i am not sure. we used the pipe we purchased to vent our wood pellet heating stove. thanks LInda

A:  No, please refer to the appliance installation manual for proper venting type, UL listing and how to vent correctly.

A:  The manufacturer does make it in black. Home Depot only carries the galvanized. It is easy to paint with High Temp spray paint in a rattle can. You should be able to find the paint at Home Depot.

A:  Yes, the part number is 3PVL-60B. Also can be painted with Krylon BBQ paint, after cleaned with mineral spirits.

A:  i have not seen the product in black. Linda

A:  This is a type p for pellet stove.

A:  No, this is L-Vent pipe for pellet stoves. this has a stainless steel inner and b-vent has an aluminum inner, making it much less expensive.