Q:I am going to install this inside a shower enclosure to replace an existing light. Where is the GFI installed? Is it a GFI switch?
by|Mar 4, 2024
2 Answers
Answer This Question
A: Do not install it in the shower enclosure. That's DANGEROUS. I would recommend locating it 1.5 - 2 FT away from the shower enclosure. It would be great if you could hook it up to the " LOAD" side of your GFCI bathroom receptacle.
by|Mar 8, 2024
A: This fan is not rated for use in a wet location, (ie) bathrooms. Use over a shower will result in a dangerous installation and immediate unit failure. It will also void the warranty.
Mike
by|Mar 7, 2024
1 found this answer helpful
Q:there are only two speed settings on the unit: "0" and "60". how do I set it to max speed of 100 CFM?
by|Jan 21, 2024
0 Answer
Answer This Question
Q:Is this a good size for a 4x4 shower stall
by|Jan 20, 2024
1 Answer
Answer This Question
A: This should not be installed in the / right above a shower stall. First, It is dangerous and second, it wouldn't lasted a month in a wet location. 1.5-2 Ft away from the shower stall would be a bare minimum distance. Make sure you connect it to the GFCI
by|Mar 8, 2024
Q:Can the fan and light be on separate switches?
by|Jan 9, 2024
1 Answer
Answer This Question
A: Yes, I installed mine on separate switches
by|Jan 24, 2024
Q:When I take a shower and the steam from the shower reaches the fan, the fan slows down significantly (almost turns off) and the green light starts flashing. When the steam is gone, it runs again on full speed. How to disable the this feature?
by|Dec 23, 2023
0 Answer
Answer This Question
Q:Is there a filter that needs to be changed?
by|Nov 26, 2023
0 Answer
Answer This Question
Q:Can you move the vent from the side to the back
by|Oct 23, 2023
1 Answer
Answer This Question
A: No, the duct is positioned so the damper will work correctly in a horizontal or vertical position. The fan is installed so the duct outlet is between studs or joists.
by|Jan 7, 2024
Q:This fan is not quiet at all? says 0.8 sone yet louder than my 1.2 done fan. Am I missing something?