Questions and Answers for Black Rail Connector Bracket (4-Pack)

A:  Jame, These brackets are designed to support a 2x4 nominal rail.

A:  Donald, These brackets come with stainless steel screws to help with assembly.

A:  Steve, The "shelf" on the bracket that the 2x4 rests on is 1/2 inch wide.

A:  Jimmy, These brackets are designed to be used with vertical, nominal 2 in x 4 in rails.

A:  Phil, These are designed to be used with vertical, nominal 2 in x 4 in rails.

A:  Yes it can

A:  Blaine, These brackets are designed to be installed to posts.

A:  Yes. As long as the U bracket screws into something wood 

A:  Blessed, the attachment screws that are included with these brackets are designed to be used with wooden posts.

A:  TzarIgor, We do not have a maximum weight that this bracket will hold. It is intended for use as a bracket for rail kits on a deck.

A:  Robert, the inside dimensions of this rail connector bracket is 1 1/2 in x 2 3/4 in.

A:  The inside width at the top of the “U” is 1 9/16” and the width at the opening at the bottom of the “U” is 1 1/2”. The two sides are a little flexible towards the bottom of the opening. The inside opening from top to bottom is 2 7/8”. I hope it’s helpful.

A:  As far as using on 1-1/2 wide piece, cut at an angle so the piece angles horizontally from the side of the post...it really does not work since the angled edge is now much greater/wider than the 1-1/2 inch space of the bracket. In one of my situations I did use it in a such a situation, but I cut the bracket into two L-shapes, and kind of "made it work" but it is not a great fit or solution.

A:  Kenny, These cannot be used as a multi-angle connector.