Questions and Answers for Channellock 16-1/2 in. Tongue and Groove Slip Joint Plier

A:  The CHANNELLOCK 460 has a jaw capacity of 4.25"

A:  3 3/4" but I can open them more about 5 1/2" to grab on to item, you will need both hands.

A:  Copper State makes bolts

A:  Go to the Channel Lock web site and I'm sure they help you out.

A:  Contact the manufacturer.

A:  CHANNELLOCK product has not used a nut and bolt since 1984, it uses a permanent fastener. These have not been supplied for quite some time.

A:  #460

A:  460

A:  Channellock 16-1/2 in. Tongue and Groove Plier This is how they are labled

A:  has 460 MADE IN USA stamped into the metal, is a great tool

A:  The lower jaw width is 1/4". The upper jaw is approximately 1/32" wider than the lower jaw.

A:  5/16 inch

A:  The CHANNELLOCK 426 has a nose profile of 0.47"

A:  5/16 “

A:  I’m not for sure . But I do not think Chan-o’ lock are lifetime Guarantee With that being said craftsman makes nowhere near a set of pliers Or channel locks As the CoL brand. Don’t get me wrong craftsman is a well respected brand of tool. But not in this category Tank You Always ,Raeford Hinson

A:  To be honest ,I, have yet to have to rely on a warranty. IA am fairly sure that their warranty is reasonable . As for the brand that you named .... that brand in, my humble opinion, is JUNK . I will not waste my hard earned dollar on that brand ever again !!! Channellock to me, ( especially their slip joint pliers ), is the " gold standard ".

A:  Not exactly. Craftsman if it's broke they replace. For channellock they have stipulations to get the tool replaced. Here is the link to channellocks website that can help explain the warranty. https://www.channellock.com/warranty/

A:  All CHANNELLOCK® pliers, wrenches, and drivers are warranted for material and/or workmanship. Tools are not warranted against abuse or wear from faithful service.

A:  don't know about a lifetime warranty, but at 79 years of age, being an active DIYer all my life, having used Channel Locks for more years that I care to admit, I've never had a problem, just a great tool

A:  I still think they are, it should say on the Web Site, if not give them a call.

A:  Yes it says they are. I don't know if you'd need a Home Depot receipt.

A:  Jfhjh

A:  Never had one break. My friend contacted Channellock directly with good results.

A:  All CHANNELLOCK® pliers, wrenches, and drivers are warranted for material and/or workmanship. Tools are not warranted against abuse or wear from faithful service.