Questions and Answers for Brita In-Line Shower Filtration System - Chrome

A:  One, spray. Mike

A:  57.8 percent is correct. Mike

A:  Shower head has helped with the fluoride in the water. My skin is not inflamed or dry as it was before. The water feels softer. I recommend.

A:  Easy to install, works well, I haven’t used a testing kit to check for actual difference. would recommend buying one to check it out.

A:  It adjusts so you can make it spray closer to the wall or further to the other end of a bathtub.

A:  Yes it improves it well, you do have to change the filter every 3 months but the improvement is noticeable.

A:  Hello. Thank you for this inquiry. After the removal of the existing shower head, the Brita In-Line Shower Filtration System is designed to fit any standard shower arm. The Brita Shower Replacement Filter is then designed to be used exclusively with Brita In-Line Shower Filtration System.

A:  In any shower head. Is really easy to install.

A:  This was a Brita Filter, I no longer have packaging. You could contacts the company to get further insight. I noticed this in the reviews: The product is certified by whatever NSF and ANSI standards so I feel better using it. I bought a bunch of these for my whole family because I approve of the product, and it's a great value buy

A:  Is using any water I use hot water and I see the difference. I move to central NY and the water was coming very different from where I am use to. I have not smell chlorine in the water even when the water is hot after I installed the filtration system.

A:  Hello. Thank you for this inquiry. The Brita In-Line Shower Filtration System filters the water notwithstanding the temperature of the water ....so hot or cold.

A:  Hello. Thank you for this inquiry. To ensure proper communication, noted below are Installation Instructions as found within the carton of the Brita In-Line Shower Filtration System: Step 1 Remove Existing Shower Head • Remove existing shower head from shower arm. • Clean shower arm to remove any residue or debris. Step 2 Apply Plumber’s Tape • Wrap plumber’s tape clockwise around the threads on the end of shower arm. Step 3 Install Filter System • Screw Filter System onto the threads of shower arm in a clockwise position until hand-tight. • Using wrench, tighten an additional 1/4 turn. Step 4 Flush System • Turn on water to shower head. In order for the Filter System to flush out any air and carbon fines (fine black powder) from the Filter Cartridge, allow the water to run for approximately 5 minutes.