Q:Can you put holes anywhere on the fabric. Would a 44×72 fit a window 36x64? It should?
by|Apr 10, 2024
1 Answer
Answer This Question
A: No, you may not put holes in the Panel. Use the Clips to attach to the Fabric panel and the finished Panel to the structure.
by|Apr 21, 2024
Q:Is the AstroGuard storm shutters approved for use in Miami/ Dade County, Florida?
by|Apr 9, 2024
1 Answer
Answer This Question
A: AstroGuard is approved for use in Miami-Dade county, NOA# 2023-1215.08.
by|Apr 10, 2024
Q:Can this screening replace a screen on a sliding glass door. Using the screen door that slides?
by|Mar 27, 2024
0 Answer
Answer This Question
Q:need custom size cut
by|Feb 28, 2024
1 Answer
Answer This Question
A: You may order custom sized panels as a "Special Order" from the mill-work department.
by|Feb 28, 2024
Q:How, specifically, can I install this on french doors that are on a second story patio so that I can get back into the house after installing?
by|Nov 8, 2023
1 Answer
Answer This Question
A: You can only establish egress if you have a Sliding door or an in swing door. Our "Reverse F Track" , installed on one side of the opening, will allow the Clips to mount in a reverse position so they face inwards and allow you to install or remove from the inside.
by|Nov 9, 2023
Q:The window I want to cover is 72x124. Highest wind speed is 72mph in my location (so far). Can I get away with the 72x134 piece of fabric and just leave a small gap at the bottom?
by|Oct 19, 2023
1 Answer
Answer This Question
A: Depending on the substrate you are installing on (Masonry or Timber), you must provide proper overlap.for the opening. The objective of all hurricane protection devices is to seal the openings to prevent pressure differentials from tearing off your roof. This requires the opening to be completely covered consistent with Product Approval guidelines.
Windspeed, and thus pressure rating, will determine anchor spacing.
You may order a custom size in the Millwork section as a Special Order.
by|Oct 20, 2023
Q:We're installing around a wood-framed entryway door that has a stucco band all the way around. See Photo Attached - will we install into wood frame using the 1" overlap or do we install into stucco band using 4" overlap?
by|Sep 30, 2023
1 Answer
Answer This Question
A: You will be using the 1" overlap as a stucco band is not a structural component. Use the 3 1/4" Panelmate anchor to ensure proper embedment.
by|Oct 2, 2023
Q:Is a 1" sidewalk bolt up to code for installation or is a larger one required?
by|Sep 10, 2023
1 Answer
Answer This Question
A: If you are purchasing the deluxe anchor (concrete insert anchor), a 1 1/4" sidewalk bolt is the correct bolt to use.