Q:The linked Use and Care document for the mirrored acrylic says the minimum cold forming radius is 200 x the width. I want to double check that this is true for the mirrored product as it looks like this document may be for unmirroed acrylic. Thanks!
by|Feb 20, 2024
1 Answer
Answer This Question
A: Thank you for bringing this to my attention, we will get it updated! Please refer to this link: https://plaskolite.com/docs/default-source/fab/fab011_fbk.pdf
by|Mar 12, 2024
Q:Is it dark and thick enough to block out light on one side and be reflective on the other side?
by|Jan 12, 2024
1 Answer
Answer This Question
A: Please refer to the installation instructions linked below. https://images.thdstatic.com/catalog/pdfImages/0b/0bd0b528-f621-4a56-a374-8fbc5c9e7cb0.pdf
by|Jan 16, 2024
Q:Do you cut plexiglass to size
by|Jan 10, 2024
1 Answer
Answer This Question
A: Acrylic is easy to cut with a plastic sheet cutting tool, or any fine toothed blade. You can also order custom sizes through our special order program. Please see a Home Depot associate to place an order and have the product cut and shipped directly to your home.
by|Jan 15, 2024
Q:I need this sheet cut to 40.5 inches wide and 84.5 inches long, can you cut it to those dimensions for me?
by|Jan 7, 2024
1 Answer
Answer This Question
A: You can order custom sizes through our special order program. Please see a Home Depot associate to place an order and have the product cut and shipped directly to your home.
by|Mar 17, 2024
Q:What is us suggested for the mirrored acrylic sheet to glue to drywall
by|Dec 28, 2023
1 Answer
Answer This Question
A: Please refer to the installation instructions linked below, and also in this page under product details to properly mount your acrylic mirror. https://images.thdstatic.com/catalog/pdfImages/0b/0bd0b528-f621-4a56-a374-8fbc5c9e7cb0.pdf
by|Jan 3, 2024
Q:Is this non-reflective? I want to use it to protect a painting.
by|Dec 10, 2023
1 Answer
Answer This Question
A: We currently only offer non-glare in 8x10 and 11x14 options on HomeDepot.com. Please see a Home Depot associate to inquire about a special size order and have the product cut and shipped directly to your home.
by|Jan 29, 2024
1 found this answer helpful
Q:Is it thin enough to roll up to fit in a vehicle to get home?
by|Dec 4, 2023
1 Answer
Answer This Question
A: No this material will not roll up like a poster.
by|Dec 5, 2023
Q:Can you lazer engrave over this?
by|Nov 28, 2023
1 Answer
Answer This Question
A: Yes, it can. Please see the excerpt below from the fabrication guide.
Laser Cutting: Lasers may be used to cut virtually any images on FABBACK with minimal material
waste. The CO2 laser operates by focusing a large amount of energy on a small defined areas and
melting and vaporizing the material. It produces a clean, polished edge without saw chips. An
average of 200 inches per minute may be accomplished by using about 200 watts from a 1200 watt
laser. Annealing the sheet is recommended after cutting, especially when cementing is anticipated.
Please note: lasers can create stress along cut areas and may permanently discolor the cut line
with an amber color. Test a piece before fabrication begins.
Caution: A cool air or water mist should be in contact with the blades of all cutting devices
before and during fabrication of the sheet.