Customer Reviews for NeatHeat 30/07 Original Series Right End/Wall Cap - Hot Water Hydronic Baseboard Cover (Not for Electric Baseboard)

These were perfect for covering our old rusty baseboard heaters. Fit great and so easy to install.

Color does not match my base board. These r bright white and baseboards r off white

End cap for a good products

These caps fit easily upon the baseboard cover from the same mfg and the whole assembly looks good. Took 1 star away just because they are so expensive for what it is.

Pricey, but does the job very nicely. Very easy to cut to length (I used sheet-metal snips). Installation is a snap (literally).

I just remodeled our bathroom but still had a rusty and pitted metal hot water baseboard. I didn't want to tear it out so I went on line to Home Depot and found these. It looks GREAT, very easy to put on, very durable, very easy to clean and added so much to the room.

First off, I admit that I really like this concept and am surprised that there are so few other options out there. The end caps are not made of the same material as the register cover. They are a thin and translucent plastic which means that you can see where the register cover ends behind it - like a wet t-shirt. You will also have to cut the bottoms to fit the height and the plastic is brittle, so be careful. I also think that these are much more expensive than they need to be given that they are made with an inexpensive plastic. I guess people, myself included, pay it because there are no other options. Also, a review on the front cover. This part of the product I liked. The plastic seems to be of a good quality. So much so compared to the end caps that I thought the end caps were for a different product, so I searched around that area of the store for the right caps. The clerk confirmed that the ones I was holding were the ones that went with the front cover. The one draw back to the 4 foot front cover was that it does not allow for the extra few inches to accomodate the copper pipe on both ends of a standard 4 foot baseboard heat unit. The cover is exactly 4 feet and Iike I said, the end caps show the register through it - not providing adequate cover. It's best to get a 6 foot piece and cut it down for a 4 foot register.

This piece was shipped in a box, unlike the panel which came only bubble wrapped. The endcap fits pretty good on the panel but has really sharp edges (see photo). I am not really impressed with this product line for poor quality reasons but at least it won't rust.

Looks really good. Somewhat easy to install.

Perfect fit and looks amazing was delivered fast and makes a huge difference in the way the room looks

Neatheat was very easy to put on over baseboard-just like the commercial which is never the case. The baseboard now looks very attractive as opposed to the eyesore it used to look like. Heat works as well as it ever did .

It did not fit the register. Just a bit small to properly attach to front. I will be returning it to store

Just wish I could find outside corner like the metal ones!

looks great - easy to install

They were perfect and came so wonderfully packaged shipped, but I had ordered the wrong part. Refund at the store was handled kindly in minutes. Thank you!

Extremely easy to install and it looks beautiful

Looks great, easy to install and keep clean

The end caps need to be the same material and match the design and color of the cover. They are not the same white color. They also need to be about 2 inches wider.