Customer Reviews for DreamLine Unidoor 35 to 36 in. x 72 in. Frameless Hinged Shower Door in Oil Rubbed Bronze

Many of our Unidoor components are used in different configurations, and the installation manual is designed to cover each of these. The Unidoor installation manual has recently been updated and should be available on our website shortly. The door installation is the same for each, but knowing which configuration you have ordered will make it easier to follow. The parts lists are provided for each style, however, the one extra part that you may have is the L-strike vinyl #8, which is only used for single door installation. The door glass needs to be installed first, at a height of 72". We recommend that you use 5/8" shims to ensure the proper spacing beneath the door. You can also use one of the 72" vinyl strips as a gauge to make sure that your installed door finishes at a height of 72", especially if you are installing along with panel glass. The easiest way to install the hinges is to first attach them to the door glass. Use a pair of 5/8" shims beneath the door to get the correct height, Mark the hinge locations on the wall, then remove the hinges from the door glass; drill your eight holes and install the hinges to the wall (without the inside hinge plate or door glass in the way to impede your ability to get the inside two screws in straight without scratching the hinge plate). You can use the provided wall plate shims to correct for an out of plumb hinge-side wall if necessary. The inline panel glass is then aligned with the installed door glass to ensure a tight seal. Of primary concern is ordering the correct model size based on your finished opening width. As far as water dripping off of the door onto the floor, you could use a bath mat or simply close the door after stepping out of the shower to prevent the water dripping off the glass onto the floor.