Q:Can these sheets be pre-cut to a certain size by the manufacturer and if not is there a specific way that's best to cut them? Also, is there an adhesive that you use to get them to adhere to a surface? In our case they will be used in an elevator for the panels.
by|Jan 16, 2019
2 Answers
Answer This Question
A: best cut with a router, straight bit but can also use sharp, heavy duty snips, (test first to make sure doesn't crack instead). I used contact cement as the adhesive, be sure to follow safety precautions, toxic odor, extremely flammable, but it works excellent for adhesion.
by|May 20, 2020
A: I would recommend calling the Wilsonart Hotline at 1-800-433-3222 and one of our Customer Service Representatives will be happy to assist you. We look forward to your call.
Thank you for your inquiry, Customer Service Wilsonart Engineered Surfaces
by|Aug 30, 2019
Q:which way is the grain running is the 4 up and down.
by|Mar 23, 2016
1 Answer
Answer This Question
A: The grain of Columbian Walnut, as well as all woodgrains, runs the length of the sheet. If you are needing further information regarding the grain of Wilsonart Laminates, please feel free to call the Wilsonart Hotline at 1-800-433-3222.
Thank you for the question,
Customer Service
Wilsonart Engineered Surfaces
by|May 3, 2023
1 found this answer helpful
Q:Also, how does this compare to the actual laminate countertop?
by|Jun 14, 2015
1 Answer
Answer This Question
A: Here is our DIY fabrication guide:
http://www.wilsonart.com/docs/default-source/wilsonart-documents/fabrication-fab-manual-diy-wilsonart-laminate-countertop-fabrication-guide.pdf?sfvrsn=4