Questions and Answers for Barrette Outdoor Living 4 ft. Brazilian Walnut Vinyl Lattice Divider (2-Pack)

A:  Screws are intended for wood.

A:  Pre-drill oversized holes through lattice and moulding (drill the largest hole that screw head will allow without fitting though). Center each screw in oversized holes and do not overtighten to allow for expansion and contraction of lattice. Along the top, drill and fasten every 24". Drill holes and hang through both moulding and panel.

A:  Around 0.20 inches.

A:  If they are framed already these pieces will likely not work to join them, they are meant to go on the edges to give a finished look. There are other pieces that have slits on each side to join two unfinished lattice together. If yours are already framed I would ask Home Depot advisors how to join them, I would use 3 same colored zip ties.. one on each end and one in the middle.

A:  Hello, this will not work - this will fit lattice. Thanks!

A:  I am not 100% sure of the panels that you have, but Barrette and Veranda products are made by the same manufacturer. I bought Veranda lattice and the Barrett dividers fit perfectly for my lattice.

A:  Hello James well to answer your question you would have to put some kind of frame around it being that it’s 4 foot tall I probably wouldn’t recommend that because of wind without having some good support for it because a good wind would blow it right off of there You would have to build it and do a panel so that has plenty of support and can withstand some wind gusts let me know if you have any more questions

A:  Not as far as I know, however the lattice itself is finished on all four sides (unlike typical wood lattice).

A:  Mitre the corners

A:  Not to my knowledge - I put edge channels on all exterior edges, and used the divider channel between 2 pieces. Cut the divider channel so the edge channel ran across both pieces. Glued all the caps & dividers - looks great and works for us.

A:  Hello, there is a Divider Moulding and a Cap Moulding (model # 73004699) available. Thanks!

A:  I don’t. Know, but it is certainly a great idea. In my use I didn’t need a corner, so. Didn’t’t Look for it.