A: Yes we recommend using 100% acrylic laytex paint
by|Feb 17, 2022
A: Absolutely. PVC holds paint better than wood trim.
by|Feb 17, 2022
Q:I would like ,Exterior moulding and trim in different colors . Is that choice avable.
by|Oct 19, 2021
1 Answer
Answer This Question
A: Exterior trim only comes in white
Thank you
by|Oct 20, 2021
Q:What are the best fasteners to use with this Veranda 2599 trim? I have white #8x2-1/4 in. trim screws for the 1" trim boards that I'm installing but they seem a bit large for pc trim that is only 11/16" thick with a narrow flat area.
by|Apr 27, 2019
2 Answers
Answer This Question
A: I used a nail gun to install. Bath and kitchen caulk to cover nail holes
by|Jun 25, 2021
A: There are several manufacturers that produce fasteners specifically intended for use with cellular PVC. (See list
below). You can also use fasteners designed for wood trim. They should have thin shanks, blunt points and full
round heads. Fasteners should penetrate 1½” into substrate. Fasteners should be positioned no less than ¾” or
more than 2” from end of boards. Fasteners must be weather resistant, such as stainless steel. For interior trim,
such as casing, base, quarter round and crown, use 16 gauge finish nails, 6d or 8d finish nails. Pneumatic guns
can be used ‐ rubber bumpers on the nail gun tooling will protect the moulding. Air pressure should be adjusted
based upon gun, temperature, substrate (80‐100 psi is typical). Always use the least pressure necessary to drive
the nail into the product.).Trim should be fastened to a flat solid surface. In cold weather below 40°F, predrilling
may be necessary. Do not use brads or wire nails. Staples can only be used to fasten beaded planking.
Recommended Screws:
Fasten Master Cortex® Hidden Fastening System (screw and PVC plug system)
Starborn Pro Plug® System (screw and PVC plug system)
Simpson Strong‐Tie® Trim‐Head Stainless Steel Screw
GRK Fasteners FIN/Trim Finishing Trim Head Screws (ClimatekCoated® or Phoenix Stainless Steel)
Kreg Blue‐Kote ™ Pocket‐Hole Screws (for assembling trim with pocket‐holes)
#8 gauge TrimTop 305 SS with sharp type 17 piercing point by Fasten Master
305 SS Headcote #7 or #8 trim screws with auger points
by|Apr 29, 2019
Q:I need to trim an 8×5 window. Will this cover the 8' sides?
by|Sep 29, 2018
1 Answer
Answer This Question
A: The length on this item is 8'.
Thank you
by|May 6, 2023
Q:Can this be used for interior door trimming? I am looking for something that will standup to my cats' scratching.
by|May 21, 2018
3 Answers
Answer This Question
A: This is not impervious to a cat's claws. The PVC is relatively soft. It "dents" easily. Having 6 cats in my household, I would not use this as door trim. What I might do is design and build a cat scratcher that could be attached to the wall next to the place where the cat scratches. This could be a 4" to 6" wide board wrapped in 1/4" sisal rope and placed high enough so that your cat could stretch and scratch. Cats can be trained to scratch where you want them to scratch, too.
by|May 5, 2023
A: It can be used as an interior moulding to frame a door.
Thank you
by|May 5, 2023
A: Check the width of item. If good I do not see any obstacles. Never stop improving.
by|May 5, 2023
Q:This is Primed White. Does that mean if I want it white, I should to paint it white? Or can I use it as white trim without painting?
by|Apr 6, 2017
2 Answers
Answer This Question
A: This is ready to use, does not need to be painted.
Thank you
by|Dec 1, 2018
1 found this answer helpful
A: This can be painted any color you like. You can use this as it is. I have left mine as they are; however, I am using this item as a picture shelf.