Questions and Answers for Rotozip 1/8 in. Saber Cut Wood Bits (4-Pack)

A:  Our RotoZip accessories are tested and recommended to be used with our RotoZip tools only. For further assistance, please contact us at 1-877-ROTOZIP (1-877-768-6947), Monday - Friday, 8A-5P CST.

A:  The RotoZip SC4 Bit is tested and recommended to be used with our RotoZip Tools only. For further assistance, please contact us at 1-877-ROTOZIP (1-877-768-6947), Monday - Friday, 8A - 5P CST.

A:  Yes

A:  The RotoZip SC4 Bits are not recommended to cut drywall. For further assistance, please contact us at 1-877-768-6947, Monday - Friday, 8A-5P CST.

A:  Yes, I used this on drywall and it worked well, especially on outlet and other boxes that needed cut out...but prepare for a lot of dust.

A:  Yes

A:  This can cut a variety of boards but it depends on the thickness and board hardness. I used this bit to cut 1/4" thick peg board to make holes for the electrical outlets and switch boxes. It cut thru the peg board with no problem. I've also used it to cut 1/2" MDF sheets and it worked but was slow to cut. I liked using it on the peg board but I wouldn't recommend it on the MDF sheets.

A:  Yes

A:  The RotoZip SC4 Bits can cut compose boards. For further assistance, please contact us at 1-877-768-6947, Monday - Friday, 8A-5P CST.

A:  Yes. Composite or mdf will wear the bit out faster than wood but it will.work just fine

A:  yes it can i use them on the job site every day they cut like butter just dont hit anything like nails or staple. they also make a 1/8 bit which is thicker and your roto zip should have the right collar that came with it. also the roto zip is just like a small router

A:  The RotoZip SC4 Bit will cut up to 1" thick. For further assistance, please contact us at 1-877-ROTOZIP (1-877-768-6947), Monday - Friday, 8A - 5P CST.

A:  Yes, but I would not recommend it. If you're doing a small piece it will work fine. Go slowly.

A:  Yes, You must adjust your travel speed to thickness of wood, but it will leave a smooth edge.

A:  yes

A:  It's pretty smooth, smoother then a table saw. But it will take forever to cut, because the bit gets real hot lime a drill. You must stop & pause every 30 seconds or so to cool down the bit

A:  The RotoZip SC4 Bit will leave a smooth edge when cutting wood. For further assistance, please contact us at 1-877-ROTOZIP (1-877-768-6947), Monday - Friday, 8A - 5P CST.

A:  yes as long as the blade is sharp use mine for months everyday and still going strong. i use this in the cabinet business

A:  Thanks for your question. Which DeWalt Model is that your are referring to? What do you plan to cut?

A:  As long as you tighten the Chuck on the drill as much as possible.

A:  prob rub your ball sack off

A:  Yes, I used this bit in my Dewalt cutout tool