Q:Can the glue get wet before fully cured? Was wanting to unload my boat at the ramp replaced all my bunk carpet then reload the boat and go home. Any thoughts? Thanks!
by|Apr 17, 2024
1 Answer
Answer This Question
A: We recommend protecting from rain or exposure to water until the adhesive is fully cured which typically takes 24 to 48 hours. We also recommend not subjecting the area to pooling of water after fully cured.
Customer Care
by|Apr 18, 2024
Q:Can I use this in a boat for wet location
by|Apr 15, 2024
1 Answer
Answer This Question
A: This product may be used with a boat, but the product should not be subject to pooling of water.
Customer Care
by|Apr 15, 2024
Q:Can I use this on asphalt?
by|Mar 20, 2024
1 Answer
Answer This Question
A: Thank you for your inquiry. Roberts 6700 Indoor / Outdoor Carpet Adhesive
can be used on the following substrates:
Concrete, APA rated marine grade plywood, aged asphalt paving (hot applied),
fiberglass and aluminum when surface is clean and roughened to promote
bonding.
by|Mar 20, 2024
Q:Is this product good for outdoor vertical application?
by|Mar 12, 2024
1 Answer
Answer This Question
A: The Roberts 6700 adhesive is not approved/warrantied for vertical usage. We also recommend using this product in covered areas that will not be subject to standing water when used for outdoor applications.
Customer Care
by|Mar 13, 2024
Q:Can I use this on Artificial turf im going to put down on composite decking boards on my pool deck ?
by|Feb 25, 2024
1 Answer
Answer This Question
A: Roberts 6700 is not recommended in areas that will be fully exposed to wet environments such as ponding.
Customer Care
by|Mar 5, 2024
Q:Is Roberts 6700 good to put boat carpet in
by|Feb 9, 2024
1 Answer
Answer This Question
A: ROBERTS® 6700 is a solvent-free adhesive designed for the exterior or interior installation of indoor/outdoor carpet. Always follow the carpet manufacturers specific install guidelines.
by|Feb 14, 2024
Q:Can I use this on a metal jon boat?
by|Feb 6, 2024
1 Answer
Answer This Question
A: Roberts 6700 I/O adhesive can be used over the following Substrates:
Concrete, APA rated marine grade plywood. fiberglass and aluminum substrate can be used when the surface is cleaned and abraded to promote bonding.
by|Feb 7, 2024
Q:Can this be used over kilz type stain blocking primer?
by|Feb 3, 2024
1 Answer
Answer This Question
A: No. Kilz is not recommended for use under glue down flooring installation.