Questions and Answers for Rev-A-Shelf Polymer Tip-Out Trays for Sink Base Cabinets

A:  Yes, this would be covered under warranty. Please contact Rev-A-Shelf directly.

A:  Yes

A:  Yes. I was able to use it in two different rooms.

A:  I don't remember any hinges there are screws that attach it to the cabinet door which hinges but yes we received 2 trays and hardware.

A:  Yes, 2 trays and 2 sets of hinges.

A:  Most likely not since the tip out tray is flat and must lay flat on the door.

A:  No

A:  I guess it depends on what the nature of the curve is, but this unit is meant to be mounted to a FLAT surface. Good luck with whatever you decide.

A:  No this has a straight edge

A:  You will actually have more than enough hardware.  The kit comes with 4 hinges in cases for a spit front. Follow instructions carefully and the result is great. 

A:  As long as you have a framed cabinet with face frame...not euro frameless you should not need anything else.

A:  The hinges included will allow the slab to be pulled forward. You shouldn't need any more hardware.

A:  these hinges connect the sink front to the cabinet so not sure what you're asking about "pull forward". the hinge set is all that's needed to connect the front slab of the sink base cabinet to the frame of the cabinet but they just allow the slab to tilt out, not pull out.

A:  All hardware included in REV-A-SHELF box. 2 sets of hinges ,2 polymer trays and good instructions. Ps will tilt forward. Doesn't pull out.

A:  Yes, this will work. This kit comes with (2) 14": trays and (2) pair of hinges. If you have a single slab drawer/door front you will of course only need one pair of the included hinges.

A:  No additional hardware will be needed, most cabinet fronts are flat on the inside. I have two of these under my kitchen sink behind the cabinet front.

A:  They are permanently installed

A:  They are permanently installed.

A:  It's plastic. I never put mine in the dishwasher as I felt it may deform with heat.

A:  On the front page of the instructions there is a small note that states the 'parts' should be cleaned with a damp cloth and wiped dry. The trays are heavy plastic but I don't know if they can handle dishwasher drying heat.

A:  12.5 inches

A:  12 1/2”. Tray can be removed for easy cleaning.

A:  Approximately 13"

A:  It is 12.5 inches between the screw holes. Measured screw center to screw center.

A:  12 10/16 They are very useful

A:  My clearance is 2.25 inches from the sink to the cabinet front and the shelf fits. I really don't know how shallow you can get. I think I just make it.

A:  The distance from the inside of my cabinet to the sink is about 2.5" The drawer fits fine because it is only 2.25" I installed these on my kitchen and both bathroom cabinets.

A:  My sink is 2 1/4" from the ( back of cabinet face to the face of the sink). The shelf is 2" deep. It fits fine once installed with 1/4" to spare. Not much room left over but the tip out shelf works fine with a single sink. I am not sure what happens with a double sink. Measure from the back face of the cabinet ( where the tip out shelf will be installed to see how much room you have to the face of the sink). I hope this helps. Great product for storing sink items.

A:  2 1/4”

A:  You would need a minimum of 2 1/4" to the sink.

A:  No.

A:  No

A:  This comes as a kit. So I'm not sure the tray is available individually. I bought the kit.

A:  It comes with hinges.

A:  yes