Questions and Answers for Prepac Series 9 1-Piece Black Queen Bedroom Set

A:  Unfortunately this unit is only manufactured in a queen and king size

A:  The diameter of the hole is 44mm

A:  It is 1" thick

A:  The night stands have a wire hole built into it. You pull out the lid of the hole, and run the lamp cord though it. There is space behind the drawer for the wire to be run without it interfering with the movement of the drawers.

A:  The cord feeds from the grommet on the top, behind the drawer and out the bottom of the nightstand (which has an opening at the bottom)

A:  You could, but you would need to cut the piece that is mounted to the wall, which voids the warranty.

A:  i will be using both night stand. I make sure that my room have the same measurement before buying.

A:  Yes. Both of the night stands are separate and just hang off of the supplied wall hanger track. You'll have to cut the part of the track that mounts to the wall to make it shorter (there are two pieces that mount to the wall that are around 100" total) to accommodate the shorter finished length.

A:  No it cannot be painted. It is covered by a wood-look veneer.

A:  Its Partical board with paper finish.I don't think it will paint well. But with proper preping it might work.

A:  No, painting is not recommended.

A:  The dimensions listed are correct: (107.25"W x 31.5" H x 16.5"D) and in the additional images there is an illustration showing more detailed dimensions. Ie. each night stand is 19.75"w x 15"d

A:  Yes, the headboard and nightstands are mounted to the wall and the bed is positioned in front of it.

A:  yes, the board hang on the wall, and that its what i love most, less stuff on the floor to move when i clean.

A:  There's a piece mounted to the wall, and then what you see kind of hooks onto that mounted piece to create that floating look. The set up is actually pretty easy and takes no time at all.

A:  Yes, You mount a long (in two halves) 1/2 inch thick board that has a 45 degree bevel (forming a hook) at the top to the wall first. Each of the three units then hang from this mounting board using similar boards mounted near the top of each unit. There are also plastic 1/2 inch spacers at the bottom of each hanging unit so that the are kept vertical. It did take me longer than the estimated installation time as I had to shim the unit a 1/2 inch further from my wall as there were moldings that needed the extra clearance.

A:  Yes, the headboard hangs on the wall.