Q:Will this cut through light gage aluminum acoustical panels?
by|Feb 20, 2023
1 Answer
Answer This Question
A: Hello! This Hole Saw is optimized for cuts in stainless steel, fastener embedded wood, cement board, fiberglass, plaster, asphalt shingles, aluminum and more.
by|May 20, 2023
1 found this answer helpful
Q:I?m putting in 6? round galvanized duct. Does this cut exactly 6??
by|Feb 15, 2023
1 Answer
Answer This Question
A: Hello! This hole saw creates holes 6" in diameter.
by|Jan 22, 2024
Q:Will this cut slate tile?
by|Jan 23, 2023
1 Answer
Answer This Question
A: Hello! These Bi-Metal Hole Saws are optimized for use cuts in Plastics, Metals, Wood.
by|Jan 23, 2023
Q:will a milwaukee arbor # 49-56-7250 arbor fit this 4 1/2 " holesaw
by|Oct 17, 2022
1 Answer
Answer This Question
A: Yes, it will fit. I have one.
by|Nov 7, 2022
2 found this answer helpful
Q:How deep will it cut
by|Oct 5, 2022
1 Answer
Answer This Question
A: I think it is pretty obvious, only as deep as the hole saw blade is. If your wood is thicker than the saw, use a drill bit to drill the remaining guide hole all the way through and then use the hole saw from the other side to line up perfect and finish the hole.
by|Feb 26, 2024
3 found this answer helpful
Q:does this cut fiberglass
by|Sep 12, 2022
1 Answer
Answer This Question
A: Hello- this Hole Saw is optimized for cuts in stainless steel, fastener embedded wood, cement board, fiberglass, plaster, and asphalt shingles.
by|Jul 30, 2023
1 found this answer helpful
Q:I need to cut 1 hole through 1/4? cement board then 1 1/2? wood. Will this do it.
by|Jun 29, 2022
3 Answers
Answer This Question
A: Check the depth of the blade, as it might not cut through 1 1/2" thickness.
by|Jul 3, 2022
A: Yes, this can do it. I've used it several times for the same purpose. My experience has been that the cement board will dull the teeth quite a bit if you plan to use it for more holes down the road.
by|Mar 28, 2023
A: Don't use it on cement board. Use a diamond hole saw to cut through the cement, and THEN this for the wood.
by|Jul 24, 2022
Q:Will it safely cut Onyx countertop?
by|Jun 17, 2022
1 Answer
Answer This Question
A: Hi Dave, we would recommend using our masonry diamond bits for that job.
by|Jun 28, 2022
Q:i need a 7-inch drill bit to go through eps styrene with a very clean hole
by|Jun 17, 2022
1 Answer
Answer This Question
A: Hi - I wouldn't use a hole saw for that. They tend to be fairly coarse (look at how far apart the teeth are). I think you will get the cleanest hole in EPS using a hot wire knife with some sort of template if you don't want to free-hand it.
by|Jun 4, 2023
Q:what is the length of the hole saw from after the teeth to the bottom? also if I cut out a round piece of wood with the whole saw would the round piece of wood inside the hole saw be less than 3-1/2 thick because hole saw is not paper thin
by|Jun 9, 2022
1 Answer
Answer This Question
A: Hi wolfbuilder! Our Milwaukee 3-1/2 in. Hole Dozer Carbide Hole Saw is 4.97" long and 5.94" wide.