Questions and Answers for MetalTech 7 ft. x 4 ft. Steel Scaffolding Cross Brace Stabilizer to Increase Scaffold Tower Load Capacity, 4-Pack

A:  Good day, TRD-16GA1X35.246PE Round tube Ø1" - 16GA with hole TRD-16GA1X35.5ECPE Round tube 16GA X Ø 1" - punched with hole Regards

A:  Scaffold cross braces seem to be somewhat standard. I have frames from three or four different manufactures, and it works with all of them. I can't say for certain if it will work for Biljax frames. But my guess is it probably will.

A:  Good day, The Metaltech product that you are looking at, it's doesn't have any compatible item with the BilJax. Regards Thank you.

A:  Cross braces yes. Frames no.

A:  Good day, once the braces are closed they measure 96.747 inches long and the wholes are 0.563 inches

A:  98" hole is 5/8"

A:  They are available as single units through 8 packs at differentiated pricing. Whether 2 is one of them,, I don't know. Individual members are longer than 7 feet designed to cross brace a 4 ft by 7 ft rectangle to keep it from racking. They do flex a tiny amount.

A:  You should verify with Home Depot if they are available in a 2-pack. These cross braces are used in scaffold towers. We cannot recommend it for any other type of use since they have not been tested . Thank you!

A:  These are sold as an 8 pack . I would NOT use these for anything other than what the manufacturer has mode them for . They are not intended for use as bed support .

A:  Good afternoon, this cross brace does not fit our Baker. An option could be adding another set of horizontal brace (where the platform sits on) to square up the scaffold. Thank you

A:  Hello, yes we can supply 3' x 7' braces, Model # M-MC3684

A:  Hello, our Bake scaffold does not need cross braces. It only comes with horizontal braces to support frame. Thanks!

A:  for hole 0.5 inch