Questions and Answers for Lutron Maestro Dual Voltage Motion Sensor Switch, 6-Amp/Single-Pole, Goldstone (MS-OPS6M2-DV-GS)

A:  Hello! No, you cannot use two MSCL-OP153M together in a 3-way application. Your options would be to either use the companion dimmer model MA-R or use a standard toggle on/off switch in the second location. If you still have questions or concerns, please give us a call at 1-844-LUTRON1. We're here 24/7, so you can reach out anytime, day or night.

A:  Thank you for your inquiry. This sensor is incompatible with the Caseta System or other Lutron App systems.

A:  The MS-OPS6M2-DV must be connected to a ground wire to function. This can be seen under the "Important Notes" section of the install guide here: https://www.lutron.com/TechnicalDocumentLibrary/0301647.pdf. However, Lutron has many occupancy sensors. Please reach out to Lutron's 24/7 Tech Support by phone at 1-888-588-7661 or by email at support@lutron.com for recommendation.

A:  Hello Keith, thank you for your question. The Maestro motion sensor switches are only rated for in-wall installation, vertically in a junction box in order to operate properly. They are not intended for ceiling-mount installation. If you have any further questions on this, we are more than happy to help. Please reach out to our 24/7 support team directly at 1-844-LUTRON1 or via email at support@lutron.com.

A:  Please reach out to our Support Team at support@Lutron.com or by phone at 1 (844) 588-7661 for assistance with your inquiry.

A:  Yes, as long as both the load wires to your different lighting circuits are connected, this device should work for your application. the MS-OPS6M2-DVR-WH is rated to switch 6 amps of lighting loads or 3A of mixed lighting/general purpose fan loads.

A:  If they are controlled by the same switch now, this switch would turn them off and on together.

A:  It might if everything runs off of a single pole switch

A:  This motion sensor is relay based so when it is in the off state, there should be no power going through the line so it should work properly in your application.

A:  I used it for led surface mount ceiling lights.

A:  yes it takes all bulbs and residential and commercial voltage

A:  Yes, the MS-OPS6M2-DVR-WH is rated to control 6A of any lighting load.

A:  Dear Valued Home Depot Customer, We reached out to MFG for more information and below is their response. " This switch would be able to work in a single pole application on a fluorescent ballast. "