Questions and Answers for Loctite Instant Mix 1 Minute Epoxy 0.47 oz. Translucent Yellow Syringe (6 pack)

A:  Thank you for the question. It is Translucent Yellow color when cured.

A:  Thank you for your question. Epoxies like the Loctite Instant Mix 1 Minute Epoxy are not recommended in applications where the bonds will be exposed to continuous water immersion or continuously wet areas. Unfortunately, it is not possible to know what results you may have or how long it can last, given this is a shower environment, if you choose to use it. The success will depend on the composition of the shelves, how well the tiled wall surface is prepared, how much bonding surface is available, and how much stress or vertical load the shelf will be subject to. We recommend you consult the corner shelf manufacture's installation instructions and recommendation before starting your project.

A:  Thank you for the question, Joe. Unfortunately, the Loctite Instant Mix Epoxy will not work for this application and would not be recommended. It will not have any flexibility on a rubber raft, resulting in failure. We recommend you contact the raft manufacturer for assistance with this repair.

A:  Thank you for the question. The Loctite 1 minute Instant Mix Epoxy is not tested for for use in potable water systems and would not be recommended for the application described.

A:  Thank you for the question. Yes, the Loctite Instant Mix 0.47 fl. oz. 1 Minute Epoxy will work on aluminum depending on the scope or nature of the project. As with all projects the intended application should be tested first prior to starting the project to ensure suitable and acceptable results.

A:  yes it does not quickly

A:  Thank you for the question. This epoxy should set in 1 minute and be fully cured in 24 hours under normal conditions. If thus is not the case then something else is wrong. Please call our Technical Help Line at 1-800-624-7767 so can obtain additional information about the intended use and help you. Thank you.

A:  Thank you for the question. The Loctite® Instant Mix 1 Minute Epoxy product is a reactive chemistry and contains epoxy resin, polymercaptan and amine curing agents. Full cure time is approximately 24 hours. These products should be used with adequate ventilation during application and curing times as indicated by the warning statements on the product packaging. Any lingering vapors will dissipate with time by providing plenty of fresh air ventilation until product is fully cured. Time frames can range from 1 hour to 24 hours or more depending upon temperature and humidity conditions, where the product was used, and the volume of product used.

A:  Thank you for the question. Extra mixing nozzles are not available for sales. The Loctite Instant Mix 1 Minute Epoxy comes with two mixing nozzles. Each one is good for one-time use. Keep in mind that just because the static mixers have been used does not mean the remaining epoxy is not usable. One only needs to dispense equal amounts of the resin and harder on to scrap cardboard or into a small paper cup and mix by hand.