A: The PowerLine Tape Measure Holder is designed for tape measures
by|Apr 10, 2023
Q:Does it fit a Milwaukee belt clip from an M18 impact or similar?
by|Jul 14, 2019
3 Answers
Answer This Question
A: It would hold the tool I'm just not sure how well it would stay in. My tape measure is a tight fit so it would probably hold it in pretty good. I can test it later and see how it holds. I will edit this once I have tested the combination and know how it holds.
by|May 8, 2021
1 found this answer helpful
A: The Klein Tools model # 5707 PoweLine Tape Measure Holder is designed to hold most tape measures with belt clips.
by|Feb 18, 2023
1 found this answer helpful
A: Yes...I wear it all day long...it's part of my personal uniform...it's good 2 go with M12, M18, tape measure & tool pouches...make sure U have a strong belt...I haven't had any problems with it getting caught on anything...hope this helps...God Bless
by|Dec 27, 2023
3 found this answer helpful
Q:What is the overall height and width of the item?
by|Oct 12, 2017
2 Answers
Answer This Question
A: It is 5'' x 4''.
by|May 5, 2023
A: The Klein Tools model # 5707 PowerLine Tape Measure Holder is approximately 4-1/8” x 3-3/4”
by|May 5, 2023
Q:Can you clip a walkie talkie to this... or too shallow/narrow of an opening? If not - do you have one like this that can
by|Jul 23, 2017
1 Answer
Answer This Question
A: The Klein Tools model # 5707 PowerLine Tape Measure Holder is designed to hold most tape measures with clips up to 1-3/4” wide.
by|May 4, 2023
Q:Will it fit a 3" leather tool belt
by|Apr 16, 2017
2 Answers
Answer This Question
A: No, this will not fit a 3" leather tool belt.
by|May 4, 2023
A: The Klein Tools 5707 PowerLine Tape Measure Holder fits belts up to 2-1/4”
by|May 4, 2023
Q:on the pic it looks like velcro on one pic then on a different looks like you can pit a belt in in it
and if so up till what size belt will fit
by|Apr 11, 2016
5 Answers
Answer This Question
A: It is not velcro; it slided on the belt (I have 2"). The problem I have with it is it will not side over the buckle or ajusters, so you are limited where it can go. The loop does need to be longer so it can fit in those places that are in easy reach without interfering with tool pouches.
by|May 4, 2023
A: This product is made of nylon.
by|May 3, 2023
A: Both. The belt goes through it but it has Velcro on the backside so if your belt has Velcro it will Velcro to the belt also.
by|Feb 3, 2022
1 found this answer helpful
A: There is a small patch of velcro on the back...however there is a loop to put a belt through, which is how I use it. As a warning, the material is a little flimsy, but I think it is still much better than putting my tape on pockets or directly to belt
by|May 4, 2023
A: The Klein Tools model # 5707 PowerLine Tape Measure Holder is designed for use with the PowerLine Tool belts, but it features a tunnel loop that will fit any belt up to 2-1/4 in. wide.