Questions and Answers for KRAUS Kore 30 in. Undermount Single Bowl 16 Gauge Stainless Steel Kitchen Workstation Sink w/Integrated Ledge and Accessories

A:  Hi Susan, We currently only offer this model with an off-set drain on the right hand side.

A:  Yes I believe so!  We like it very much.  The only criticism is that I wish there was more ‘slope” towards the drain. It does require you to rinse all the bits down to the drain.

A:  Hi J1S1, Yes, this sink is made of 16 guage T304 stainless steel.

A:  Yes

A:  Constructed from proprietary KRAUS TRU16 – the thickest 16-gauge stainless steel for superior durability and resistance to dents and damage, our Gun Metal finish features an innovative finish application resuling in a brilliant and functional color coating that bonds completely to the steel, improving durability with superior resistance to abrasion, chips, and corrosion. The sandblasted matte texture also resists water spots and fingerprints while enhancing the aesthetic appearance of the sink with a shimmering effect. Hope this helps. Please feel free to reach out to us at 800-775-0703 or via email at customerservice@kraususa.com and we would be happy to assist. Thank you for reaching out.

A:  Hi Ykub, That would ideally depend on the type of faucet as some models require additional space for handle clearance. Our faucets require an 1 3/8" hole for installation and based on your measurements, this may be a tight fit.

A:  Yes it should be fine. I have mine mounted in a 30" cabinet and it fits fine. As the bowl itself is 25 inches there is a 1" rim all the way around and if mounting into countertop the holes are 1/2" past that. The rest of the space is for the undermount clips.

A:  Thanks for reaching out. Yes, we recommend a 30" cabinet as there will be space needed to accomodate the mounting hardware included with the sink.

A:  Hi Nick, Thanks for reaching out to us. Yes, the minimum recommended cabinet size for this sink is 24". Please also see the included accessories below: Accessories Included Strainer ST-1 Cover Cap STC-2 Bottom Grid KBG-101-21 Cutting board KCB-WS15 Cut-Out Template Mounting Hardware

A:  Hi Skiran, This divider is 4 1/2" in height. Please feel free to reach out to us at 800-775-0703 or via email at customerservice@kraususa.com with any additional questions. Thank you for reaching out.

A:  Thanks for reaching out and happy to carify. Please see a list of accessories included with this sink: Accessories Included Strainer ST-1/PGM Cover Cap STC-2/PGM Bottom Grid KBG-UN1-27/PGM Rolling Mat KRM-11BL Cutting Board KCB-WS103BB Cut-Out Template Mounting Hardware

A:  Hi Jdeez, Yes - please also note the drain will then be on the front end of the sink

A:  Yes, garbage disposals are 100% compatible with our sinks. Rather than install a disposal to the drain, the disposal will replace the drain as it has its own flange and mounts directly to the sink. Please feel free to reach out to us at 800-775-0703 or via email at customerservice@kraususa.com and refer to your case number. You can also contact me directly at mrodriguez@kraususa.com Thank you for reaching out.