Questions and Answers for Greenstar Touch'n Hold Smooth Single Kit (Cranberry) - Standard Duty Pneumatic Door Closer for Storm and Screen Doors

A:  Absolutely! You will want to install this in the same location as you would the Anderson door closer, but it should work great for that door.

A:  Hi Misty, Yes. The Touch 'n Hold comes with a 2-Year limited warranty that covers any issues that arise as a result of a manufacturer's defect. It does not cover physical damage such as misuse or wind damage. Thanks for your question!

A:  Hi Jenny, Thanks for the question. Generally, yes! These can be used as replacement closers or as upgrades for most Anderson doors. It depends a bit on the type of Anderson door your installing it on, but as long as the door is already equipped with a cylinder style closer, then using the Touch 'n Hold shouldn't be any problem. Most likely you won't even have to remove your old brackets (a lot of times you can just swap out the closers). But please follow the instructions to make sure the positioning of the brackets is correct to ensure the best experience.

A:  Hi TamieJ, Yes. The Touch 'n Hold Smooth door closer is very quiet. Thanks!

A:  14 inches

A:  The cylinder length is 12 inches. The total length is longer, but the Touch 'n Hold matches the industry standard length for door closers.

A:  Yes, this is a genuine Greenstar product

A:  No, the closers will most liekly not work in unison causing multiple issues. Mike

A:  Yep! That shouldn't cause any issues. However, to maximize the smooth closing function of the Touch 'n Hold door closer, it's best to go with the Touch 'n Hold Smooth Dual Kit and replace both the top an bottom closers.

A:  Thanks for the question. All of our Touch n Hold kits come with 2 x brackets (door and jamb), and the screws and connector pins required for installation. All you'll need is a power drill for pre-drilling holes for installation into a new door.

A:  Everything you need except tools. New brackets for door, both ends. Screws. Pins. Rubber rings to keep pin from slipping out. Diagram.