Questions and Answers for Glacier Bay Invee Single-Handle Pull-Down Sprayer Kitchen Faucet with Optional Deck Plate in Oil Rubbed Bronze

A:  Thank you for your question, this faucet does not feature the spot resistant finish.

A:  I am not sure what spot resistant Stainless is per say, I can tell you that i am very happy with this faucet and it always looks good with minimal cleaning. I usually just wipe it down with a sponge and dry it with a paper towel and it looks brand new. Have had zero problems with its performance. It is well made and for the price you really cant go wrong.

A:  Thank you for your question, it is only necessary to use silicone in the deck plate installation, to keep the plate in place.

A:  I say no. It looks quite sleek with out it and I think it's easier to clean

A:  If you have a three hole set up, then use the deck plate. It's recommended that you seal anything that goes through your counter top. A small thin bead of clear silicone sealant will do the trick nicely if you put the bead around the top of the hole. Hope this helps.

A:  Yes if you have a single hole mounting. The base plate isn't necessary for the installation

A:  Thank you for your question, the deck plate is optional.

A:  it pulled down far enough but it wasn't a smooth pull. When I pulled it down it put to much stress on the entire faucet

A:  Thank you for your question. According to the specification document on the product page, the spout extends 9 7/16th inches, or 239 mm into the sink.

A:  There is a weight that goes on the hose underneath the sink. Did you install it when you put the faucet in? You should still be able to feed it in without it; did you check under the sink to make sure the hose is not resting against something or getting hung up on a pipe or valve?

A:  Did you install the return weight? If not, install it on the lowest part on the spray side of the hose, before the hose returns to the base. That will fix the problem.

A:  Had the same problem but I think I resolved it. Check the weight. The closer the weight to the faucet the better, but the trick seems to be that the spay head "snaps" in place with a bit of force. It will NOT retract by itself and if you slowly push it back it will not snap. Use your palm and slap lightly. It will snap in place. Works every time for me now and I hope it lasts.

A:  The product does come with hot/cold connectors but I had to add an extension to one of the lines because it was not long enough.

A:  It comes with ends that connect to you on/off valves, but not the valves themselves.

A:  Everything necessary for installation is provided

A:  Thank you for your question. The hoses to connect to hot and cold water supplies are included.

A:  The plate is 2 7/16" wide.

A:  Thank you for your question. The dimensions in the specification document list the deck plate as 10 1/4" by 2 7/16".

A:  It is 2 3/8" deep amd 10 1/4" wide.

A:  Thank you for your question.15 13/16", or 15.81 inches is the correct measurement.

A:  The Glacier Bay Invee 8 in. Single-Handle Top-Mount Pull-Down Sprayer Kitchen Faucet has a height of 15.81 inches.

A:  The pdf with specs states the reach is 9 7/16".

A:  Thank you for your question. Please contact the Customer Care Center at 1-855-434-5224 and we'll be happy to help you trouble shoot this.

A:  Thank you for your question. Please contact the Customer Care Center at 1-855-434-5224 and we'll be happy to help you trouble shoot this.