Questions and Answers for Everbilt Gray Door Silencers (12-Pack)

A:  They will fit in the 1/4" hole but it's depending on the thickness of the peg board if they will stick

A:  This is for use on doors with metal frames.

A:  This is designed for metal door frames and requires a 1/4" pilot hole.

A:  They'll probably fit into the hole of a peg board, but I think the peg board is too thick so they may not snap in to hold good.

A:  Where the door hits the metal door frame you must drill 1/4" holes. Then just push them in, if you have any trouble just use small allen wrench to push it in.

A:  yes, drill a hole I think the YouTube video recommended slightly bigger than quarter inch... but haven't tried it yet.. u push it into the door... this type is for hollow metal door... u can use sth like a nail or sth to push it in, I've seen a tool but don't know how to get, I think nail will be fine... put 3 top to bottom

A:  there is a link above that says 'instructions for installation' or sth

A:  Yes, you do need a hole. If you don't want to drill holes, you can always buy similar items that have adhesive on one side. They seem to stick fairly well since the pressure of the closed door holds them onto the metal.

A:  Yes, it will require a hole to go into. Please contact the manufacturer for the instructions.

A:  they spend a lot of time answering this question on YouTube when what I wanted was the how to instructions... on my door there is little space for the edge of the door to abut the edge of the door jamb... but i'll have to live with it, as long as they stay in they should work even tho half of the silencer is going to not be functioning between door and jamb... it may look a little hokey but as long as it works i'll be fine w it... look like roughly half inch maybe a little less... the good thing is that the bag supplies a reasonable number of them, only 12 not 100 like most purchasing options I've seen...

A:  The bumper is about 1/2" and the hole needs to be about 1/4".

A:  The door silencers are 1/2" round and fit metal doors with 1/4" hole's in the frame. the total length of the silencer is about 1/2". I think you can use them on a wood frame door if you drill a 1/4" holes in the frame. to insert them you use a 3/32" allen wrench in the the top of the door silencers and just push it in the hole.

A:  This product is designed to be used on metal frames.

A:  Does home depot have the ones for wood door frames?

A:  there is another kind for wood door, it doesn't have a cone shape it has a ... like a big real fat short nail shape....

A:  No, made for metal frame doors with the 1/4" holes all ready in the frame. But if you drill a 1/4 in hole in the wood frame you may make it work. There cheep so give it a try and let us know if it works

A:  Drill a 1/4" hole in the frame and incert with the 3/32" allen wrench.