Questions and Answers for Emsco Easter Island Sandstone Resin Head Statue

A:  It weighs about 6 pounds without water or sand

A:  It only weighs about 5 ounces. It is hollow resin. It will blow over if not weighted down. There is a rubber stopper on bottom for sand or rocks to be added.

A:  This weighs about 27 pounds.

A:  plastic and hollow so maybe 3lbs

A:  Don't know. Very light.

A:  For getting the cap off, I would take a flat head screwdriver and push it under the lip of the black cap. Push it down and away from yourself!! It is a plastic plug and flexible so it should distort and pop out of the hole. I hope this helps. Thanks and good luck.

A:  Squirt some soapy water on the edge and let it sit awhile. Gently use a putty knife that isn't sharp and work your way around.

A:  we used a big screwdriver to open it

A:  yes... a bit tough to remove cap. I bought two. I had to use a butter knive slowly around the cap.

A:  About 3 ft

A:  2.5ft without a tape measure but good size

A:  This item is 27 inches in height.

A:  The hole would probably need to be enlarged or the bottom cut out to cover a pipe.

A:  you can open up the hole in the bottom to about 6 inches

A:  I think hole only big enough to fill with sand, but probably could be cut to fit sewer connection.

A:  This hole is not big enough to hide a sewer cleanout. Please look at some of our landscape rocks to hide this type of item.

A:  the hole on the bottom is 4" diameter.... if your pipe is bigger you can cut the hole a little larger