Questions and Answers for Ekena Millwork 1/2 in. x 152 in. x 6-1/8 in. Polyurethane Panel Crosshead Moulding

A:  The product width specification given, is the bottom width. For example, the 43" bottom width crosshead, has a top width of 46 1/8". If you chose another size, feel free to visit the "Product Overview" section on this page and it will give both the bottom and top width dimensions, of each size. Feel free to reach out with any additional questions.

A:  It is the overall width.

A:  Hello! Unfortunately not. However, we offer on that is very close and the item number is CRH07X. They come in a number of widths, but the 7" crosshead has a 1" bottom projection.

A:  Yes, you can install this on a stucco exterior. Below is a link for the installation instructions. https://images.homedepotstatic.com/catalog/pdfImages/74/74e1f484-fbf7-4324-9c14-cec5e69f7ff7.pdf Basic installation instruction is to Fasten using Loctite PL Premium Construction Adhesive and any necessary fasteners. Also seal the edges using an exterior grade silicone sealant around the perimeter to seal around all the edges to prevent moisture from getting between the Moulding and the stucco surface.

A:  Typically it is the measurement of the window itself, plus the width of any trim surrounding the window.

A:  Thank you for your question and interest in our products. These Polyurethane Panels arrive primed and are meant to be painted on site.

A:  Thank you for your interest in our products. When you select the product width, you are selecting the width of the bottom of the crosshead. The top will be wider than the bottom.

A:  Thank you for your question Luke. The flat surface in the middle has a projection of approximately 1/4" and the very bottom of the crosshead is 1/2" thick.

A:  The 33" at the widest point across.

A:  Yes you can simply return it to Home Depot.

A:  Hi Micio, thank you for showing interest in our products, I am happy to assist you with any product questions that you might have. Yes our polyurethane products can be easily cuter and mitered to sit flush on the wall. If you have any question, feel free to contact us directly at sales@ekenamillwork.com and we will get back to you quickly.

A:  Yes, this product can easily be cut.

A:  Hi Micio, You may cut this molding with a miter saw, you will need a fine tooth carbide blade of the best results. Always wear safety glasses when cutting any material, especially this kind of material as it creates many small fragments which may get into your eyes. Mike