Questions and Answers for Dremel 7000 Series 6-Volt Alkaline Dual Speed Cordless Rotary Tool Pumpkin Carving Kit with Stenciling Templates

A:  The 7000-Pk is a 6V with 5000 and 13,000 RPMs. Any accessories with fit on the collet nut, the only thing is that the accessories require different RPM usage. Depending on the application, you may be able to use this tool. There are different types of EZ-lock accessories; grinding, cutting, polishing and sanding. This tool is for a light applications due to the volts and RPMs.

A:  Unfortunately this tool does not come with a battery pack but takes AA batteries.

A:  The battery is sold separate through Dremel at (800) 437 3635.

A:  This kit includes the following: 6.0V Dremel Alkaline Cordless Rotary Tool, Ten carving templates, 191 High Speed Cutter and Wrench.

A:  the drill comes with one tool

A:  It does come with a small "carving" tool, but I recommend investing in a bigger bit because if you use the one it comes with you will be there for a while.

A:  It does come with a carving "bit", but I would recommend purchasing a bigger bit or you'll be there for a while if you use the one it comes with.

A:  The bit is # 191 and can be sold separately.

A:  It easy to put on

A:  When you purchase the Pumpkin Carving Kit, you get a tool, bit and stencils for this application.

A:  It is a stand alone tool, but can be used with other Dremel accessories. The tool does not have a lot of torque but would be OK for very light duty work. Unfortunately, the operating instructions specifically tell you that it cannot be used as a Dental Drill. Too bad!

A:  It is it's own self contained tool. I would say it is a Dremmel with less speed control. It comes with one bit for stenciling.

A:  No. One bit is included in the kit, but standard Dremel cutters will work in the tool.

A:  The tool comes with one bit for carving.

A:  Thank you for inquiring on our products. Unfortunately, there is not an accessory kit available for the 7000-PK. However, this tool can accept bits with a 1/8" shank down to a 1/32" shank providing the correct size collet is used. I hope this information helps. If you have further questions, please call Dremel Customer Service at 1-800-437-3635. Our hours of operation are Monday-Friday from 7am-6pm CST.